download
- Remove engine cover (arrows). – Remove noise insulation panel (arrows). – Remove front bumper. Refer to Body and Frame/Bumper/Service and Repair – Move lock carrier to service position. Refer to Body and Frame/Radiator Support/Service and Repair – Remove ribbed belt. Refer to Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Serpentine Belt/Service and Repair See: Drive Belt/Service and Repair CAUTION: Mark the running direction of the belt with a crayon or marker before removing. Reinstalling a used belt in reversed running direction could damage the belt. – Unclip toothed belt guard on both sides and remove. – Turn crankshaft by hand to TDC. Marks -A- and -B- must align Check position of camshafts. Larger holes (arrow) of securing plates on camshaft sprockets must be on inside and must align If they are not in this position: Turn crankshaft one revolution further. – Remove sealing plug from left-side of cylinder block. Top Dead Center (TDC) mark on crankshaft must be visible or can be felt – Install 3242 crankshaft holder into opening. – Remove tensioner for ribbed belt. – Remove center and left belt guards. Notes: The toothed belt tensioner is oil-dampened. Compress it by slowly applying constant pressure. Use spring clamp from 2024A.
Related posts:
- 2002 Audi A4 Sedan Timing Belt: Service and Repair Toothed Belt, Removing and Installing
- 2001 Audi A6 Quattro Timing Belt: Service and Repair Toothed Belt, Removing and Installing
- 1996 – 2002 Audi B5 Platform Engine removing and installing
- 2001 Audi A6 Quattro Water Pump: Service and Repair Coolant pump, removing and installing
- 1996 – 2002 Audi B5 Platform 2.7 Liter V6 5V BiTurbo Engine Camshafts and camshaft adjusters removing and installing
