download
Note instructions for disconnecting and connecting battery. Refer to Service Precautions. See: Service Precautions/Technician Safety Information – Disconnect battery ground wire and mask it. – Loosen the screws; remove the reinforcing pipe. – Remove cover (1) from fuel lines. – Unclip fuel lines (2) and line for reversing light (3) from bracket. 1997 BMW 328i (E36) L6-2793cc 2.8L DOHC (M52) – Unfasten nuts and remove cable. Installation: Note line routing. Tightening torque, refer to chart below – Unfasten screws from top and bottom of starter motor. If installed: – Unfasten nut (1) on support and remove starter. Installation: – - Check starter pinion and starter crown gear for damage. Dismantling and reassembling starter motor, refer to Disassembling and Assembling Starter Motor See: Disassembling and Assembling Starter Motor Component Torque Chart
Related posts:
- 2003 BMW X5 REMOVING AND INSTALLING OR REPLACING FAN COUPLING (M62)
- 1997 BMW 740i Removing and Installing fan for heater and air conditioner (control)
- 1997 BMW 740i Removing and Installing Instrument Panel Trim, Dash Board
- 2005 BMW 745Li Removing and installing or replacing brake linings on both rear disk brakes
- 2001 BMW X5 Alternator: Service and Repair Removing And Installing/ Replacing Alternator (M62)
