s p o n s o r e d   l i n k s


2003 Buick Rendezvous Water Pump Replacement Removal Procedure

0

Filed Under (Buick) by admin on 08-07-2010

Tags: , , , ,

download
1. Drain the cooling system until the coolant is below the level of the water pump. 2. Remove the drive belt guard. 3. Loosen the water pump pulley bolts. 4. Remove the drive belt. 5. Remove the water pump pulley bolts. 6. Remove the water pump pulley. 7. Remove the water pump bolts. 8. Remove the water pump. 9. Remove the water pump gasket. 10. Clean the water pump mating surfaces. Installation Procedure 1. Install the water pump gasket. 2. Install the water pump Notice: Refer to Fastener Notice in Service Precautions. 3. Install the water pump bolts. Tighten the bolts to 10 Nm (89 inch lbs.). 4. Install the water pump pulley. 5. Install the water pump pulley bolts. 6. Install the drive belt. Tighten the water pump pulley bolts to 25 Nm (18 inch lbs.). 7. Install the drive belt guard. 8. Fill the cooling system.

Related posts:

  1. 2003 Buick Park Avenue Ultra Water Pump Replacement Removal Procedure
  2. 2003 Buick Park Avenue Ultra Drive Belt Idler Pulley Replacement (Lower) Removal Procedure
  3. 2001 Buick Regal Power Steering Pump Replacement
  4. 2003 Buick Century Engine Oil and Oil Filter Replacement Removal Procedure
  5. 2003 Buick Rendezvous CX DIFFERENTIAL CLUTCH PUMP CHECK VALVE Removal Installation

Comments are closed.

Related Items: , , , , , , , , , , , , , , , , , , , , , , ,