download
Removal Procedure Caution: Refer to SIR Caution in Service Precautions. 1. Disable the SIR system. 2. Remove the upper and lower trim covers. Important: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes. 3. Remove the wire harness assembly (1) from the wire harness strap (2). 4. Disconnect the turn signal and multifunction switch assembly connector from the SIR system coil connector. 5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1). 2004 Buick LeSabre V6-3.8L VIN K 6. Remove the 2 pan head tapping screws (1) and (3) from the turn signal and multifunction switch assembly (2). 7. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly. Installation Procedure 1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly. Notice: Refer to Fastener Notice in Service Precautions. Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.
Related posts:
- 2004 Buick LeSabre Steering Column Trim Covers Replacement
- 2003 Buick LeSabre HEADLAMP REPLACEMENT REMOVAL PROCEDURE
- 2000 Buick LeSabre Canister REMOVAL PROCEDURE
- 1995 Buick Skylark Turn Signal Flasher – Location Revised
- 2000 Buick LeSabre Canister Vent Valve Service and Repair REMOVAL INSTALLATION PROCEDURE
