Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the trim panel surrounding the radio and includ- ing the a/c vents. (Figure A) 3 Remove (4) Phillips screws securing the radio. (Figure B) 4 Disconnect and remove radio. (Figure B) Continue to KIT ASSEMBLY. 1 KIA RIO: Cut and remove shaded areas #1. (Figure A) HYUNDAI ACCENT: Cut and remove shaded areas #2. (Figure A) 2 Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure B) 3 Slide the aftermarket head unit into the cage until secure. (Figure C) Continue to final assembly.

download
REMOVAL 1. Remove the wheel and tire. 2. Drain the gear oil or transaxle fluid. 3. Remove the cotter pin and driveshañ nut from the front hub 4. Remove the 2 bolts and disconnect the ball joint from the knuckle. 5. Using a plastic hammer, separate the driveshaft from the axle hub. 6. Push the axle hub toward the outside of the vehicle, and separate the driveshaft from the axle hub. Center bearing bracket 7. Insert a pry bar between the center bearing bracket and the driveshaft, and then pry the driveshaft from the transaxle. (2.7L ENG.) NOTE: Do not pull on the driveshaft, doing so will damage the D.O.J, or T.J. be sure to use the pry bar.Insert a pry bar between the transaxle case and the driveshaft, and pry the driveshaft from the transaxle (Except 2.7L ENG.) NOTE: Do not pull on the driveshaft, doing so will damage the D.O.J.; be sure to use the pry bar. Do not insert the pry bar deeply enough to damage the oil seal CAUTION: Do not apply the vehicle weight to the wheel bearingwhile the driveshaft is disconnected If the vehicle’s weight must be applied (because of vehicle movement or some other reason), use the special toot to hold the wheel bearing, as shown in the figure. 9. After releasing the auto tensioner, remove the drive belt. (2.7L ENG.) 10. Remove the alternator assembly (2.7L ENG.) 11. Remove the center bearing bracket mounting bolts. Insert the pry bar between the center bearing bracket and the cylinder block to disconnect the bracket from the cylinder block

download
PACKAGE TRAY 1. Remove the trim. NOTE: Put on gloves to protect your hands. When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. Take care not to bend or scratch the trim and panels. 2. Installation is the reverse of removal. NOTE: Replace any damage clips. Vehicle Level Body and Frame Interior Moulding / Trim Rear Shelf Service and Repair Service and Repair

download
1. Remove the center facia panel. 2. Loosen the screws 3. Disconnect the audio connector (A) and antenna cable (B), then remove the audio assembly (C) Vehicle Level Accessories and Optional Equipment Radio, Stereo, and Compact Disc Service and Repair Removal and Replacement Removal and Replacemen

download
FRONT CONSOLE REPLACEMENT NOTE: When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. Put on gloves to protect your hands. Take care not to scratch the trim and other parts. 1. Remove the crash pad center lower cover. 2. Remove the front console upper cover (A) and disconnect the connector (B). 4. Installation is the reverse of removal. Interior Moulding / Trim Console Service and Repair Front