Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
REMOVAL PROCEDURE 1. Loosen the positive crankcase ventilation (PCV) valve hose clamp (2). 2. Remove the PCV valve hose (3) from the PCV valve. 3. Remove the PCV valve (1) from the cylinder head. INSTALLATION PROCEDURE 1. Install the PCV valve (1) into the cylinder head. NOTE: Refer to Component Fastener Tightening Notice in Service Precautions. Tighten the PCV valve to 27 N.m (13 lb ft). 2. Connect the PCV valve hose (3) to the PCV valve (1). 3. Secure the PCV valve hose with one clamp (2).

download
REMOVAL PROCEDURE 1. Remove the inside door handle bezel. 2. Remove the upper door trim panel. 2.1. Use the J 38778 in order to release the retainer at the top of the upper door trim panel. 2.2. Lift the upper door trim panel upwards in order to remove. 2.3. Disconnect the wire harness to the tweeter. INSTALLATION PROCEDURE 1. 2. 3. 4. Snap the jack screws (1) into the power drive unit (4). Push the mirror assembly in close to the power drive unit (4). Align the swivel (6) on the power drive unit (4) to the pivot points in the mirror backing plate. Push in the backing pirate until a click is heard.

download
1. 2. 3. 4. Disconnect the electrical connector at EGR valve. Remove the 2 EGR Valve retaining nuts. Remove the Linear EGR valve assembly. Remove the gasket. INSTALLATION PROCEDURE 1. Clean the intake surface and install the gasket. NOTE: Refer to Fastener Notice in Service Precautions. 2. Install the linear EGR valve assembly and two bolts. Tighten Tighten the nuts to 30 N.m (22 lb. ft.). 3. Connect the electrical connector.

download
1. 2. 3. 4. 5. Disconnect all the electrical connectors at the ignition control module. Note position of spark plug wires for installation and disconnect the spark plug wires from ignition coils. Remove the screws securing coil assemblies to ignition control module. Disconnect the coils from ignition control module. Remove the ignition control module from the bracket. INSTALLATION PROCEDURE 1. Install the ignition control module on the bracket. 2. Install the coils to ignition control module. NOTE: Refer to Fastener Notice in Service Precautions. 3. Reinstall the screws. Tighten Tighten the screws to 4.5 N.m (40 lb in). 4. Connect the spark plug wires as noted during removal. 5. Connect the electrical connectors to the ignition control module.

download
REMOVE OR DISCONNECT 1. Disconnect negative battery cable. 2. Remove starter motor. 3. Disconnect sensor harness connector at module. 4. Remove sensor to block bolt. 5. Remove sensor from engine. Inspect Inspect sensor O-ring for wear, cracks or leakage. Repace as needed. Lube new O-ring with clean engine oil before installing. INSTALL OR CONNECT 1. Sensor into block. 2. Install bolt. Tighten Bolt to 8 Nm (71 lb. in.) 3. Connect sensor harness connector at module. 4. Install starter motor. 5. Connect negative battery cable.