Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
Starting December 1999, the 2000 MY Land Cruiser came equipped with a factory installed towing converter system. The new converter system will require installation of a sub–harness (Service P/N 08921–60820) from converter to hitch which will be available in all PIO/DIO hitch kits (PT228–60003). This converter system is not interchangeable with the previous Trailer Harness Kit (P/N PT207–60994). This bulletin provides a ten step procedure for replacing the new factory converter in case of repair or maintenance. Also provided is a procedure for functional verification once replacement is complete. Service Part Number 08940–60810 is to be ordered in the case of converter replacement. This service part contains the converter and wiring harness for the vehicle side. It does not contain the sub–harness (P/N 08921–60820) used from converter to hitch.

download
If the Sienna power sliding door becomes inoperative, intermittently inoperative, does not close properly, or returns to the open position while being closed using the power switch or remote control, follow the diagnostic procedure outlined in this bulletin.
Since the 2000 – 2002 model year Repair Manuals contain additional diagnostic and repair procedures (compared to the 1999 Repair Manual) it is recommended that only the 2000 – 2002 model year Repair Manual be consulted when making repairs to the
Power Sliding Door Assembly(s). Additionally, if the powered operation of the door becomes inoperative, the door may be manually operated only if the main power switch (located on the left side of the steering column) is switched “OFF.” THE POWER DRIVE ASSEMBLY MAY BE DAMAGED INTERNALLY if manual door operation is attempted when the main power switch is in the “ON” position.

download
Introduction The sliding door front striker plate and lock assembly on 2004 – 2006 model year Sienna vehicles have been redesigned in order to address customer complaints of rattles that occur under certain driving conditions. The improved front striker plate and lock assembly have a new coating that will reduce noise from contact between the front striker plate and the sliding door lock assembly when in the closed position. Refer to TIS: S 2004 or 2005 model year Sienna Repair Manual: Engine Hood/door: Slide Door: Overhaul.
S 2006 model year Sienna Repair Manual: Engine Hood / Door: Slide Door: Disassembly and Reassembly, Installation.

download
Some owners of 1999 and 2000 model year 4Runner vehicles may complain of fuel gauge operation problems. These complaints may include: S The gauge reading will gradually change while driving or will show a different reading after cycling the ignition key “OFF” and then “ON”. S The gauge will come off of “FULL” quickly. S The perception that the fuel tank capacity is less than it should be, or differs from the capacity stated in sales literature. To improve these concerns, a new Circuit Plate No. 3, fuel sender gauge and suction tube assemblies have been developed. Repair 1. Replace Combination Plate No. 3. Procedure A. Verify that the replacement circuit board has been ordered with the correct vehicle mileage for that vehicle. See important note on page 2. B. Remove the combination meter assembly. C. Remove Circuit Board No. 3. D. Replace the circuit board with the new part.

download
Introduction Customers in areas with extremely low ambient temperatures may complain of poor heater performance during city driving conditions. The Air Conditioner Unit Assembly has been modified to improve this condition. S 2003 – 2005 model year Corolla vehicles produced BEFORE the Production Change Applicable Replacement
Install Air Conditioner Unit Assembly. Procedure Air Conditioner Unit Assembly 1. Evacuate Refrigerant HFC–134a (R–134a).
S Equipment: Robinair R–134a Refrigerant Recovery/Recycling Machine (Robinair P/N: 342000) 2. Disconnect Negative Terminal of Battery. 3. Drain Coolant.