Filed Under (Ford) by admin on 21-03-2011
Multi-Function Switch Removal 1. Disconnect battery ground cable (14301). 2. Tilt column to lowest position and remove tilt steering column lock lever (3F527). 3. Remove ignition switch lock cylinder (11582). 4. Remove shroud screws and remove upper steering column shroud (3530) and lower steering column shroud. 5. Remove two self-tapping screws retaining multi-function switch (13K359) to steering column casting. Disengage multi-function switch from casting. 6. Disconnect the two electrical connectors. Installation 1. Install two electrical connectors to full engagement. 2. Align mounting holes in multi-function switch with corresponding holes in steering column casting. Install two self-tapping screws, making sure to start screws in the previously tapped holes. Tighten to 2-3 Nm (18-26 lb-in). 3. Install upper steering column shroud and lower steering column shroud. 4. Install ignition switch lock cylinder. 5. Install tilt steering column lock lever. 6. Connect battery ground cable. 7. Check steering column and multi-function switch for proper operation.