Filed Under (Ford) by admin on 08-04-2011
download
1. Remove door latch cover by pulling trim free of retaining clips and sliding trim away from latch. 2. Remove portion of armrest containing door lock switch and window regulator control switch (14529). Trim Panel 3. Remove screw attaching front door trim panel (23942) to front door (20124). 4. Remove two screws located at bottom of front door trim panel. 5. Disconnect the door lock switch (14028) and window regulator control switch electrical connectors. 6. Remove rear view outside mirror mounting hole cover assembly by prying at top and pulling upward to release double-sided clip. 7. Pull front door trim panel from the top to release fasteners from front door. 8. Remove front door trim panel. Disconnect lamp connector. 9. To install, reverse Removal procedure. Replace any bent or damaged fasteners. Body Side Removal and Installation 1. Remove door handle retaining clip by sliding a shop towel between handle and door trim. With tension on the cloth, pull one end of the cloth so it slides between the handle and the door trim. If handle does not come out, reverse direction. 2. Gently pry door latch bezel from door trim. 3. Pull body side trim panel from body side door. 4. To install, reverse Removal procedure. For installation of handle, install clip to handle, then push handle on to shaft to snap in place. Back Removal and Installation 1. Disconnect rear window defroster wires. 2. Remove the liftgate window garnish moulding. Refer to procedure in this section. 3. Remove screws attaching liftgate handle to liftgate and liftgate inside trim panel. 4. Using Rotunda Windshield and Moulding/Trim Removal Kit 107-R0401 or equivalent, pry pushpins retaining liftgate trim from the liftgate. 5. Remove liftgate trim. 6. To install, reverse Removal procedure. Liftgate Door Electrical Connections
