1. Remove the battery tray. For additional information, refer to Section 414-01. 2. Remove the air cleaner outlet pipe and air cleaner. For additional information, refer toSection 303-12. 3. Recover the A/C refrigerant. For additional information, refer to Section 412-00. 4. Raise and support the vehicle. For additional information, refer to Section 100-02. 5. Remove the lower radiator air deflectors. 6. Drain the engine cooling system. For additional information, refer toSection 303-03. 7. Drain the engine oil. Install the drain plug. 8. Lower the vehicle. 9. Disconnect the fuel hose spring lock coupling. For additional information, refer toSection 310-01. 10. Remove the water pump drive belt. For additional information, refer to Section 303-05. 11. Disconnect the accelerator cable and, if equipped, the speed control actuator cable. 12. Disconnect the vapor management valve (VMV) connectors. 13. Disconnect the powertrain control module (PCM) electrical connector. 14. Disconnect the ground wire. 15. Disconnect the hoses. 16. Remove the tie-strap and disconnect the heater hose. 17. Disconnect the electrical connector from the power distribution box. 18. Remove the power distribution box cover. 19. Remove the nuts and the cables. 20. Disconnect the transaxle linkage. 21. Disconnect the brake booster vacuum hose. 22. Disconnect the vacuum hose at the vacuum reservoir check valve. 23. Disconnect the power steering return tube. 24. Disconnect the power steering hose. Disconnect the power steering pressure (PSP) switch electrical connector. Remove the bracket bolt. Disconnect the power steering hose. 25. Remove the oil level indicator. 26. Disconnect the ground strap and the connector. 27. Remove the wiring harness retainers and position the wiring harness out of the way.