download
Turn OFF the ignition. Remove the air cleaner outlet duct. Remove the air intake pipe from the turbocharger. Disconnect the electrical connector (2) from the boost pressure sensor (3). Remove the nut (4) retaining the boost pressure sensor bracket and the coolant tube. Lift the coolant tube (1) off of the stud and move it out of the way. 7. Remove the boost pressure sensor (2) and the bracket (1) from the intake manifold. 8. Remove the bracket from the sensor. 9. Inspect the boost pressure sensor seal for damage and replace as necessary. INSTALLATION PROCEDURE 1. Position the bracket (1) over the sensor (2). 2. Install the boost pressure sensor into the intake manifold and guide the bracket over the stud. 3. Position the coolant tube (1) over the stud. NOTE: Refer to Fastener Notice in Service Precautions. 4. Install the retaining bolt (4). Tighten Tighten the bolt to 9 N.m (80 lb in). 5. Connect the electrical connector (2) to the boost pressure sensor (3). 6. Install the air intake pipe to the turbocharger. 7. Install the air cleaner outlet duct.
Related posts:
- 2000 GMC Jimmy INTAKE MANIFOLD REPLACEMENT – UPPER Removal Procedure
- 2003 GMC Envoy Accelerator Pedal Position Sensor Service and Repair REMOVAL PROCEDURE
- 2002 GMC K 1500 Yukon camshaft position (CMP) REMOVAL PROCEDURE
- 2009 Holden VE Sedan Front Side Door Trim Panel Replacement Removal Procedure
- 2002 GMC Yukon Denali HANDLE BEZEL REPLACEMENT – INSIDE Removal Procedure
