1994 Jeep Wrangler Fuel Filter Service and Repair

0

Filed Under (Jeep) by admin on 21-08-2010

download
WARNING: The fuel system is under constant pressure, even when the engine is OFF. Always release fuel pressure before servicing any fuel system component. Fuel Filter And Shield REMOVAL 1. Disconnect the negative battery terminal, and remove the fuel tank cap. 2. Raise, and support the vehicle for access. 3. Remove the fuel filter shield. Remove fuel filter hoses and clamps from the inlet and outlet fuel lines. Remove the retaining strap bolt, and remove the filter. INSTALLATION 1. Install the new filter in the retaining strap. Check the direction of flow by the markings on the filter, and ensure it is correct. 2. Install the retaining strap bolt, and torque to 12 Nm (8.8 lb-ft) 3. Install the inlet and outlet hoses, and clamps. Tighten the clamps securely. Reinstall the filter shield, and lower the vehicle. Reconnect the negative battery terminal.Using the DRB II select the Automatic Shut Down (ASD) Fuel System Test to pressurize fuel system and check for leaks. Refer to Powertrain Management / Computers and Control Systems / Testing and Inspection / Procedures See: Powertrain Management\Computers and Control Systems\Testing and Inspection CAUTION: Unless the test is stopped or the ignition switch is turned to the OFF position the fuel pump relay and the ASD relay will remain energized for 7 minutes by the ASD Fuel System Test.

  1994 Jeep Wrangler Fuel Filter Service and Repair Direct Download speed 4887 Kb/s

  1994 Jeep Wrangler Fuel Filter Service and Repair Full Version speed 5767 Kb/s

Comments are closed.