download
IGNITION TIMING NOTE: Perform all adjustments with engine at normal operating temperature, cooling fan and accessories off, transmission in Park or Neutral, and front wheels in straight-ahead position. NOTE: Adjustment of ignition timing cannot be performed on vehicles equipped with Distributorless Ignition Systems (DIS). If ignition timing is not within specification, see CRANKSHAFT POSITION SENSOR in I – SYS/COMP TESTS article in this section. 1) Locate ignition timing adjustment connector. See IGNITION TIMING ADJUSTMENT CONNECTOR LOCATION table. Connect jumper wire between ignition timing adjustment connector and ground. Check ignition basic timing. 2) If ignition basic timing is not within specification, loosen distributor and rotate to adjust timing if necessary. See IGNITION TIMING SPECIFICATIONS table. Remove jumper wire from ignition timing adjustment connector.
Related posts:
- 1992 Mitsubishi Mirage ADJUSTMENTS FRONT WIPER ARM ADJUSTMENT
- 1993 Mitsubishi Diamante PRELIMINARY INSPECTION & ADJUSTMENTS
- Mitsubishi Cordia, Tredia, Precis, Mirage, Galant Repair Manual 1983-1993
- 1992 Mitsubishi Mirage TRANSMISSION REMOVAL & INSTALLATION – A/T
- 1993 Mitsubishi 3000GT Timing Belt: Service and Repair
