download
When installing camshafts, camshaft bracket, oil seals, or other sliding parts, lubricate contacting surfaces with new engine oil. – Apply new engine oil to threads and seat surfaces when installing cylinder head, camshaft sprocket, and camshaft bracket. Do not put hydraulic lash adjusters (HLA) upside down, otherwise air will enter HLA, causing it to make a noise. Do not disassemble HLA. Attach tags to HLA so as not to mix them up. HLA should be immersed in engine oil. Installation 1. Set No.1 piston at TDC on its compression stroke as follows: a. Align crankshaft sprocket aligning mark with mark on oil pump body. b. Align camshaft sprocket aligning mark with mark on timing belt rear cover. 2. Install cylinder head with new gasket. Caution: – Be sure to install washers between bolts and cylinder head. – Do not rotate crankshaft and camshaft separately, or valves will hit piston heads. 3. Install cylinder head bolts. Install short bolts “L2″ into the correct holes of cylinders #1 and #6 as shown in image of step 4 f. Apply engine oil to threads and seating surfaces of cylinder head bolts before installing them.
Related posts:
- 1990 Nissan 300ZX Cylinder Head Assembly: Service and Repair Removal
- 1998 Nissan Altima SE CYLINDER HEAD Removal (240SX, Altima & Frontier)
- 1995 Nissan 200SX Engine – Timing Chain/Front Cover Revised Procedure
- 1994 Nissan Pickup SE TIMING CHAIN Removal Inspection Installation
- 1998 Nissan Sentra TIMING CHAIN Removal
