download
Open the hood. The first step is to remove the grill. It is held on by 8 square clips along the top and bottom, and 4 clips on the sides that snap into the headlight housing. Nissan Titan Headlight Bulb Replacement Using a flat-head screwdriver, rotate each of the 8 square clips by 1/8 turn (in either direction) and gently pull on the grill until the square head slips trough the slot. To access the lower clips, you will have to look in the big opening below the grill. This is where the flashlight may be useful. Once you’ve loosened the 8 square clips, you will need to unsnap 2 clips located on both ends of the grill. The following photo shows where the clips are snapped into. Nissan Titan Headlight Bulb Replacement From behind, use a flat-head screwdriver to press on the side of the clip and gently pull on the grill to unsnap it from the hole. Repeat for the lower clip. Again a flashlight may be useful to locate the lower clip. The end of the grill should be completely free. Now unsnap the two clips on the other end of the grille and remove the grille.
Related posts:
- Nissan Titan/ RaceRunner 2.5” Dia. Front Coil-Over Installation
- 2008 – 2010 ARMADA & TITAN AND 2008 – 2009 QUEST BRAKE PEDAL PIVOT PIN INSPECTION
- 2004-2005 NISSAN TITAN COIL SPRING LEVELING 2.5” KIT INSTALLATION INSTRUCTIONS
- 2004-2009 Nissan Titan 5.6L Banks Ram-Air® Intake System Installation
- 2004 Nissan Maxima CENTER CONSOLE Disassembly and Assembly
