Filed Under (Pontiac) by admin on 04-01-2011
SERVICE PROCEDURE Front Door Glass Bolt Replacement Caution: Avoid hands and face being caught by the front door glass when adjusting the height of the front door glass. 1. Adjust the front door glass to align the position of the front door glass bolt with the service hole. 2. Approximately 100 mm (4 in) from the top of the front door trim board, mark off 80 mm (3 in) with tape. 3. Adjust the front door window glass to align with the tape marking. Notice: Unhook the clip before unhooking the claw to prevent breaking the bracket garnish. 4. Remove the clip and unhook the claws to remove the front door lower frame bracket garnish. Notice: Wrap protective tape around the head of the flathead screwdriver to avoid scratching the power window switch or trim board. 5. Using a flathead screwdriver with protective tape wrapped around the head, remove the six (6) clips and claws to separate the power window switch. 6. Remove the power window switch: For LH – Unlock and remove the connector. Refer to the illustration. 2092983 – For RH (with door lock switch) – Disconnect the two (2) connectors. – For RH (without door lock switch) – Disconnect the connector. 2092928 7. Remove the screw from the door pull handle, and remove the handle. Notice: Wrap protective tape around the head of the flathead screwdriver to avoid scratching the power window switch or trim board. 8. Remove the screw. 9. Remove the front door trim board. Notice: Avoid damaging the inside handle when removing the trim board. 10. Remove the eight (8) clips and remove the trim board. Notice: Pull the service cover up carefully to avoid damaging the service cover. Notice: Do not allow butyl tape to adhere to any parts. 11. Pull up on the service hole cover until the bolt for the front door glass is visible, and then secure the cover in place with tape.