download
CHECK THAT PEDAL HEIGHT IS CORRECT Pedal height from floor panel: 42.8-152.8 mm (5.62-6.02 in.) If the pedal height is incorrect, adjust it. IF NECESSARY, ADJUST PEDAL HEIGHT (a) Remove the under cover. (b) Remove the lower pad and air duct. (c) Remove the power steering ECU and disconnect the connector from the stop light switch. (d) Loosen the stop light switch lock nut and remove the stop light switch. (e) Loosen the push rod lock nut. (f) Adjust the pedal height by turning the pedal push rod. (g) Tighten the push rod lock nut. Torque: 25 N?m (260 kgf?cm, 19 ft?lbf) (h) Install the stop light switch and turn it until it lightly contacts the pedal stopper. (i) Return the stop light switch one turn. (j) Check that the clearance (A) between stop light switch and pedal. Clearance: 1.5-2.6 mm (0.06-0.10 in.) (k) Tighten the stop light switch lock nut.
Related posts:
- Turn off your Check Engine light
- Troubleshooting Anti-lock Brake System (ABS) Indicator Light
- ANTI-LOCK BRAKE SYSTEM System Components System Description
- HOW – TO FUEL PUMPS MECHANICAL FUEL PUMP REPLACEMENT
- Tips for Power Steering Inoperative/Steering Wheel Hard to Turn 2005-2008 Chevrolet Cobalt 2006-2008 Chevrolet HHR 2005-2006 Pontiac Pursuit (Canada Only) 2007-2008 Pontiac G5 2003-2007 Saturn ION
