1982 gmc Sierra


You are searching repair manual in PDF format about 1982 gmc Sierra use another keyword for search another post or files



  1982 gmc Sierra Direct Download speed 5787 Kb/s

  1982 gmc Sierra Full Version speed 6767 Kb/s




| Sierra, Silverado, Suburban, Tahoe, Yukon (VIN C/K) Service Manual | 2001 GMC Truck GMC K Sierra – 4WD

0

Filed Under (GM) by admin on 12-06-2010

download
Test Description The numbers below refer to the step numbers on the diagnostic table. 2. Allow the engine to cool before performing this test. If the sensor is at the operating temperature, the HO2S voltage will stay high or low. If the HO2S voltage stays between 300-700 mV this indicates the HO2S heater is inoperative. 3. If more than one HO2S DTC is set, this is a good indication that the HO2S fuse is open. Test all the related circuits going to all the heated oxygen sensors for a short to ground. If you cannot locate a shorted circuit, it may be necessary to disconnect each HO2S one at a time to locate a shorted sensor. 4. This step determines if an ignition positive voltage supply is available at the sensor.

2005 GMC Truck Sierra Steering – Underhood Clunk Heard/ Felt in Steering Wheel

0

Filed Under (GM) by admin on 26-06-2010

download
Subject: Clunking Noise Under Hood and Can Be Felt in Steering Wheel and/or Steering Column(Replace Upper Intermediate Steering Shan [I-Shaft] Assembly) Models: 2002-2006 Cadillac Escalade Models 1999-2007 Chevrolet Silverado Models (Classic) 2000-2006 Chevrolet Suburban, Tahoe Models 2002-2006 Chevrolet Avalanche 1999-2007 GMC Sierra Models (Classic) 2000-2006 GMC Yukon, Yukon XL Models 2003-2006 HUMMER H2 A The lower steering column bearingmay create the same noise as the intermediate shaft. Before replacing the I-shaft, verify the noise isn’t being caused by movement from the lower steering column bearing. Check the bearing for movement by pushing up and down on the I-shaf where it attaches to the steering column A Frame Snap and/or Popping Type Noise – A frame snap or popping type noise can be duplicated on rough or smooth road surfaces with steering wheel input to the left or the right. This type of noise can be HEARD and is typically louder with the windows rolled down. For additional information refer to Corporate Bulletin Number 03-08-61-002F or newer – Snap/Popping Type Noise Coming from Front of Vehicle (Remove Front Crossmember Change Fastener Orientation

PERFORMANCE & SERVICE PARTS GUIDE Merkur XR4ti / Sierra XR4i / Sierra RS Cosworth / Sierra RS 500 / Merkur Scorpio

0

Filed Under (Ford) by admin on 01-10-2009

BAT is pleased to be able to offer this line of components for the U.S. specification “Merkur” XR4ti, Scorpio and the other European models of Sierra lineage. European Sierra models have been manufactured since 1982 and include
two versions or body styles. We will concern ourselves with the Mark 1 as it is more similar to our U.S. version. The high water marks of the MK1 series are the XR4i and the Sierra Cosworth and R/S 500 models. From the exterior, XR4i is very similar to the U.S. Merkur XR4Ti in overall looks. However, under the hood it is powered by a 2.8L V-6 engine
where we have the 2.3L 4 cylinder turbo

download

2008-2009 GMC Canyon, GMC Envoy 2008-2009 Saab 9-7X Engine Runs Rough (Inspect for Water Intrusion in Spark Plug Recess Area, Replace Spark Plug and Ignition Coil, Seal Ignition Coil Bolt Hole Vents and Seal Hood Air Grille)

0

Filed Under (GM) by admin on 04-06-2010

download
Models: 2008-2009 Chevrolet Colorado, TrailBlazer 2008-2009 GMC Canyon, Envoy 2008-2009 HUMMER H3, H3T 2008-2009 Saab 9-7X All Equipped With Engine RPOs LLR, LLV, LL8 Please Refer to GMVIS Condition Some customers may comment that the malfunction indicator lamp (MIL) is illuminated. Some customers may also comment that the engine runs rough. The technician may find DTCs P0300, P0301, P0302, P0303, P0304, P0305, or P0306 set as current or in history, depending on which engine the vehicle is equipped with. Upon further examination, the technician may observe evidence of water intrusion into the spark plug recess area. Cause This condition may be caused by an engine being exposed to a large quantity of water, which may result in some of the water seeping down past the vented threads of an ignition coil bolt, then flowing through the vent opening that is located in the bottom of the related ignition coil bolt hole, and collecting in the spark plug recess area. Correction Important: DO NOT reprogram or replace the engine control module (ECM) for this condition. If evidence of water intrusion in the spark plug recess area/s is not observed, then refer to the appropriate DTC procedures in SI.

2003 GMC Truck C 1500 Engine Knock or Lifter Noise (Replace 0-Ring)

0

Filed Under (GM) by admin on 20-05-2010

download
2001-2002 Chevrolet Camaro 2001-2003 Chevrolet Corvette 2001-2002 Pontiac Firebird 2002-2003 Cadillac Escalade, Escalade EXT
2000-2003 Chevrolet Suburban, Tahoe 2001-2003 Chevrolet Silverado 2002-2003 Chevrolet Avalanche 2000-2003 GMC Yukon, Yukon XL 2001-2003 GMC Sierra with 4.8L, 5.3L, 5.7L or 6.0L V8 Engine (VINs V, T, Z, G, S, N, U – RPOs LR4, LM7, L59, LS1, LS6, LQ9, LQ4)
Condition Some customers may comment on an engine tick noise. The distinguishing characteristic of this condition is that it likely will have been present since new, and is typically noticed within the first 161-322 km (100-200 mi). The noise may often be diagnosed as a collapsed lifter. Additionally, the noise may be present at cold start and appear to diminish and then return as the engine warms to operating temperature. This noise is different from other noises that may begin to occur at 3219-4828 km (2000-3000 mi).