1987 nissan stanza


You are searching repair manual in PDF format about 1987 nissan stanza use another keyword for search another post or files



  1987 nissan stanza Direct Download speed 5787 Kb/s

  1987 nissan stanza Full Version speed 6767 Kb/s




2005 – 2009 Nissan FRONTIER, Nissan XTERRA, Nissan PATHFINDER, FRONT AIR BAG CRASH ZONE SENSOR

0

Filed Under (Nissan) by admin on 04-01-2011

download
SERVICE PROCEDURE 1. Set the parking brake. 2. Connect C-III to the vehicle. 3. Use C-III to check for Air Bag DTCs. a. Navigate C-III to Air Bag Direct Diagnostic Mode. b. Make sure to check both SELF DIAG RESULTS and SELF-DIAG [PAST]. • SELF-DIAG [PAST] is under Special function. • If there are any DTCs stored for AIR BAG other than B1033, B1034 and/or B1035, perform repairs as needed, and then erase DTC before continuing with this procedure. • Diagnosis and repair for DTCs other than B1033, B1034, and/or B1035 is not covered by this bulletin. NOTE: All DTCs (except B1033, B1034, and B1035) must be repaired and erased before continuing with this procedure. 4. Disconnect C-III from the vehicle. 5. Start the engine and let it idle for about 5 seconds. 6. Turn the ignition OFF. 7. WARNING: Prep the vehicle for Crash Zone Sensor replacement as follows: The following are VERY IMPORTANT to prevent unexpected air bag deployment. • Remove the ignition key / Intelligent Key from the cabin of the vehicle and set aside, away from the vehicle (this will prevent accidentally turning the ignition ON). • Make sure the ignition remains OFF until after the new sensor is completely installed. • Make sure no one is in the vehicle cabin and no one enters the vehicle cabin until after the sensor is completely installed. • Wait for all control units to “power down” (at least 1 minute) before continuing. 8. Locate the Crash Zone Sensor (see Figure 2). Crash Zone Sensor Cover 9. Remove the 2 Crash Zone Sensor nuts shown in Figure 3. • Discard these nuts. They will not be reused. 10. Remove the Crash Zone Sensor Cover. 11. Disconnect the electrical connector shown in Figure 4.

Related entry:

2000 nissan xterra idle air control system, hb12 nissany sunny carburetor rebuilb pfd, nissan vanette cargo manual, how hard is it to replace a vanette clutch, how to assemble a nissan 1400 gearbox, nissan b13 repair manualfree, how to reset security system nissan xterra, 2001 quest p0740, 2001 pathfinder fuse removal horn, nissan sentra p0350 code,

NISSAN PERIODIC MAINTENANCE SCHEDULE NISSAN MICRA

0

Filed Under (Nissan) by admin on 11-04-2010

download
ENGINE MAINTENANCE (Petrol Engine) Replace engine oil Replace engine oil filter Inspect drive belts Inspect cooling system
Page 1© NISSAN NISSAN PERIODI CMAINTENANCE SCHEDULE NISSAN MICRA 15,000 KM Inspect brake, clutch and automatic
trans-axle fluids Inspect manual trans-axle gear oil Inspect power steering fluid and lines Inspect brake, clutch and exhaust systems
Inspect steering gear and linkage, axle and suspension parts and front driveshafts Inspect wheel alignment (if necessary rotate
tyres and balance Inspect brake pads, rotors and other brake components Inspect brake linings, drums and other brake
components Inspect foot brake, parking brake and clutch Lubricate locks, hinges & hood latch Inspect seat belts, buckles, retractors,
anchors & adjuster Clean or replace ventilation filter Replace brake fluid (Severe conditions only)

Related entry:

change aerial on micra, service schedule for nissan micra, reset maintenance notification in murano, 2010 nissan frontier passenger side airbag wiring harness, service schedule nissan primera, rogue air bag code b1035, nissan serena 2000 model throttle position sensor for the gearbox, Nissan Micra Service Schedule, nissan micra 03 interior light how to change, nissan caravan zd30 problems,

2004 Nissan 350Z Navigation Guide

0

Filed Under (Nissan) by admin on 20-10-2009

Page 1 Thank you for purchasing an NISSAN automo- bile. This user’s manual is for the navigation system only. This manual contains operating
instructions for the NISSAN Navigation System offered in the NISSAN 350Z. Please read this manual carefully to ensure safe
operation of the navigation system. ? Please read your vehicle’s owner’s manual first. ? Do not remove this manual from the vehicle when selling this vehicle. The next user of this navigation system may need the manual. ? Because of possible specification changes, sections of this manual may not apply to your vehicle. ? All information, specifications and illustra- tions in this manual are those in effect at the time of printing. NISSAN reserves the right to change specifications or design at any time without notice. Page 2 Page 3 CONTENTS INTRODUCTION …………………………………………………………………… 1-1 HOW DOES THE NISSAN NAVIGATION SYSTEM WORK?……………………….. 2-1 WHAT FEATURES ARE AVAILABLE ON THE NISSAN NAVIGATION SYSTEM? …. 3-1 HOW DO I OPERATE THE NISSAN NAVIGATION SYSTEM? …………………….. 4-1 HOW DO I PROGRAM A DESTINATION?…………………………………………. 5-1 HOW DO I USE THE POINT OF INTEREST (POI) FEATURE? ……………………. 6-1 HOW DO I USE THE ADDRESS BOOK FEATURE?……………………………….. 7-1 HOW DO I USE THE AVOID AREA FEATURE? …………………………………… 8-1 HOW DO I USE THE AUTOMATIC REROUTING FEATURE? ……………………… 9-1 HOW DO I USE THE VOICE GUIDANCE FEATURE?…………………………….. 10-1
HOW DO I ADJUST THE DISPLAY? …………………………………………….. 11-1 HOW DO I USE THE VEHICLE INFORMATION? ………………………………… 12-1 INFORMATION ON MAP DATA DISCS………………………………………….. 13-1 TROUBLESHOOTING GUIDE …………………………………………………….. 14-1 INDEX ……………………………………………………………………………. 15-

download

Related entry:

nissan caravan manual, 230jm manual, 350z convertable top diagram, 350z top frame repair, nissan wingroad service manual, nissan wingroad workshop manual, Nissan wingroad y11 manual, power steering Nissan hb12 workshop, puedo instalar autohub en nissan frontier, nissan serena 2000 model manual,

2003 – 2005 Nissan Altima 2004 Nissan Maxima ENGINE IS HARD TO START WHEN WARM

0

Filed Under (Nissan) by admin on 04-06-2010

download
The engine is hard to start when warm, but starts OK when the engine is cold. NOTE: “Hard start” is engine crank time that is longer then 3 seconds. • If you only have DTC P0340, replace only Bank 1 CMP (Camshaft Position) Sensor. • If you only have DTC P0345, replace only Bank 2 CMP (Camshaft Position) Sensor. • If you have both codes, replace both sensors. • For a “hard to start warm” incident, replace both sensors, even if you have no codes. Refer to sections EC and EM in the correct Service Manual for sensor replacement information. If replacement of the sensors does not solve your incident, go back to ASIST for further diagnostic and repair information.

Related entry:

2 5 Nissan Engine cam removal, where to download fuse box diagram for 1994 nissan altima, 2005 nissan maxima mufflers, Nissan maxima 2005 exhaust diagram, removing wiring harness from 2004 Nissan maxima for engine removal, p0340 obd-ii trouble code nissan altima 2005, location of motor mount switch 2001 maxima, how to remove ecm in 2001 maxima, how to install ecm in 2003 nissan maxima, cam bearing cap torque for 1 6 nissan sentra,

2000-2002 Nissan Frontier, Nissan Xterra COOLANT LEAK FROM INTAKE MANIFOLD WATER OUTLET

0

Filed Under (Nissan) by admin on 29-05-2010

download
SERVICE INFORMATION If an applied vehicle exhibits: Engine coolant under the vehicle when parked Smell of coolant when engine is warm, The cause may be coolant leaking between the water outlet housing and intake manifold sealing surfaces (see Fig. 1 ). Refer to the SERVICE PROCEDURE to resolve this incident, should it occur. NOTE: A leak from the above noted area can be verified by a visual inspection.Fig. 1: Intake Manifold Water Outlet SERVICE PROCEDURE Install the new fiber gasket (refer to the PARTS INFORMATION section) between the water outlet housing and intake manifold as follows: CAUTION: Be careful not to spill engine coolant on electrical connectors, drive belts, etc. when performing the following procedure.