1991 Chevrolet Silverado manual


You are searching repair manual in PDF format about 1991 Chevrolet Silverado manual use another keyword for search another post or files



  1991 Chevrolet Silverado manual Direct Download speed 5787 Kb/s

  1991 Chevrolet Silverado manual Full Version speed 6767 Kb/s




2002 Chevrolet Silverado 1500 engine runs, but lacks power when driving

0

Filed Under (Chevrolet) by admin on 20-01-2011

download
Vehicle Application: Customer Concern: Tests/Procedures: Potential Causes: Diagnostic Codes: 2002 GAS, 2003 GAS, Chevrolet Silverado 1500 4.8L, Vin V, Eng Cfg V8, USA/Canada Chevrolet Silverado 1500 4.8L, Vin V, Eng Cfg V8 The engine runs, but lacks power when driving. Has codes P0101 and P0300. Scanner shows misfires all on the same side of the engine. 1. Check the catalytic converter, on the “suspect” bank of the engine, for a restricted (plugged) exhaust system to that side of the engine. 2. Disconnect both front O2 sensors, re-set the fuel trims and see if the problem goes away. 3. If gone with the O2 sensors disconnected, then swap the sensors side to side and see if the problem follows the O2 sensor. Plugged Exhaust System Oxygen Sensor P0101, P0300 2003 Chevrolet Tahoe 4.8L, GAS, Vin V 2003 Chevrolet Tahoe 5.3L, FLEX, Vin Z

1991 Chevrolet Cavalier/ Z24 Heater Control Valve: Heater – Low Output

0

Filed Under (Chevrolet) by admin on 10-09-2010

download
On customer comments of low heater output on 1989-91 J cars, before replacing a suspected defective engine cooling thermostat, proper diagnosis of the condition must be performed to avoid the possibility of a repeat repair. Follow “Diagnosis” as shown in Section 1A/1B of the appropriate Service Manual. After completing the diagnosis, use the following as a guide to the next corrective step: ^ If the diagnosis indicates a defective thermostat, refer to Section 6C for replacement. ^ If the diagnosis indicates a defective temperature control cable, refer to Section 1A/1B for replacement. ^ If the diagnosis indicates the temperature control cable is no longer “snapped” into its retainer, refer to “Temperature Control Cable Repair” in the 1991 Service Manual, Sections 1A/1B. ^ If the diagnosis indicates that the temperature control cable is out of adjustment, refer to the following procedure to repair. TEMPERATURE CONTROL CABLE ADJUSTMENT PROCEDURE Condition: Condition: Cause: Correction For Number: 1. “Spring back” off full “hot” temperature control position (or not attaining full “cold” temperature door position). 2. “Spring back” off full “cold” temperature control position (or not attaining full “hot” temperature door position). The temperature control cable “clip” needs adjustment. Refer to the illustration for correct gripping of the “clip” during adjustment. 1. Grip “clip” at module end of cable while pulling temperature control lever to “hot” position.

BMW 5-Series (E39) Repair Manual 525i, 528i, 530i, 540i, Sedan, Sport Wagon 1997-2002

0

Filed Under (BMW) by admin on 07-09-2009

Comprehensive, single source of service information and specifications available specifically for BMW 5 Series from 1997 to 2002. The aim throughout this manual has been simplicity, clarity and completeness, with practical explanations, step-by-step procedures and accurate specifications. Whether you are a professional or a do-it-yourself BMW owner, this manual will help you understand, care for and repair your E39 5 Series. Though the do-it-yourself BMW owner will find this manual indispensable as a source of detailed maintenance and repair information, the BMW owner who has no intention of working on his or her car will find that reading and owning this manual will make it possible to discuss repairs more intelligently with a professional technician.
Engines covered in this BMW repair manual:
* 6-cylinder engines: M52, M52 TU, M54
* V-8 engines: M62, M62 TU
Fuel injection systems covered in this BMW repair manual:
* Bosch M 5.2, M 5.2.1, ME 7.2
* Siemens MS 41.0, MS 42.0, MS 43.0
Manual transmissions covered in this BMW repair manual:
* Getrag S5D 250G, S6S 420G
* ZF S5D 320Z
Automatic transmissions covered in this BMW repair manual:
* A4S 270R, A4S 310R
* A5S 360R, A5S 390R
* A5S 325Z
*A5S 560Z, A5S 440Z

Toyota Camry Repair Manual 1983-1991

0

Filed Under (Toyota) by admin on 08-08-2015

service, repair & maintenance manual covers Toyota Camry, 1983 through 1991. Note: this manual does not include diesel engine information.
Table of Contents
* Introduction: Vehicle identification numbers; Buying parts; Maintenance techniques, and more.
* Tune-up and routine maintenance
* Engine and overhaul procedures
* Cooling, heating and air-conditioning systems
* Fuel and exhaust systems
* Engine electrical systems
* Emissions control systems
* Transmission
* Brakes
* Suspension and steering systems
* Body
* Chassis electrical system
* Wiring diagrams

2007 Chevrolet Impala 4T65E Transmission 1-2 Shift Shudder at Light to Moderate Acceleration (Replace Complete Second Clutch Assembly)

0

Filed Under (Chevrolet) by admin on 21-10-2010

download
Models: 2001-2004 Buick Regal 2001-2005 Buick Century, LeSabre 2002-2007 Buick Rendezvous 2005-2007 Buick Terraza, LaCrosse, Allure (Canada Only) 2006-2007 Buick Lucerne 2001-2005 Chevrolet Venture 2001-2007 Chevrolet Impala, Monte Carlo 2005-2007 Chevrolet Uplander 2006-2007 Chevrolet Malibu SS, Malibu Maxx SS 2001-2002 Oldsmobile Intrigue 2001-2003 Oldsmobile Aurora 2001-2004 Oldsmobile Silhouette 2001-2005 Pontiac Aztek, Bonneville, Montana 2001-2007 Pontiac Grand Prix 2005-2007 Pontiac Montana SV6 2006-2007 Pontiac G6 GTP 2005-2007 Saturn Relay with 4T65E Automatic Transmission (RPOs MN3, MN7, M15, M76) Condition Some customers may comment on a 1-2 shift shudder at light to moderate acceleration. Typically, the throttle plate angle parameter is 12-20% at time of condition with vehicle speed of approximately 24-40 km/h (15-25 mph). The customer may describe the condition as slip or delayed shift into second. Correction Replace the complete second clutch assembly with service kit, P/N 24240561. Refer to the GM Unit Repair Service Manual for the year and model of the vehicle being serviced for the 2nd Clutch service procedure. This service kit contains: Second Clutch Housing Fluid Seal Rings (613), a Second Clutch Assembly (617), a Case Cover (Channel Plate) Upper Gasket (430), and a Case Cover (Channel Plate) Lower Gasket (429). In addition to the content of this service kit, other gaskets not included in this service kit will also be needed to complete the repair – a Case Cover Lower Gasket (429), and a Case Cover Upper Gasket (430). These gaskets can be obtained by ordering gasket kit 24206391. Be sure to use ONLY the Second Clutch Assembly and Second Clutch Housing Fluid Seal Rings provided in this service kit. DISCARD the Second Clutch Assembly and Second Clutch Housing Fluid Seal Rings removed from the transmission being serviced. Disassemble ONLY the Oil Pump Assembly from the Case Cover (Complete). DO NOT disassemble the Control Valve Body from the Case Cover. Remove ONLY the Case Cover-to-Case bolts to remove the Case Cover and Valve Body from Transmission Case AS AN ASSEMBLY . To access all Case Cover-to-Case bolts, it is necessary to remove the Pressure Control Solenoid Valve Assembly (322), and 1-2 & 3-4 Shift Solenoid Valve