2002 buick rendezvous
You are searching repair manual in PDF format about 2002 buick rendezvous use another keyword for search another post or files
2002 buick rendezvous Direct Download speed 5787 Kb/s
2002 buick rendezvous Full Version speed 6767 Kb/s
Filed Under (Buick) by admin on 28-06-2010
Subject: Boom or Drone Noise at 2100 rpm or About 120 km/h (75 mph) (Inspect and Clean Torque Tube Mount or Install Dampener/Mount Kit) Models: 2002-2004 Buick Rendezvous AWD 2005 Buick Rendezvous AWD (w/LA1 Only) 2002-2005 Chevrolet Venture AWD 2002-2003 Oldsmobile Silhouette AWD 2002-2005 Pontiac Aztek AWD, Montana AWD Supercede: This bulletin is being revised to add a corrective action, one illustration and warranty information. Please discard Corporate Bulletin Number 04-04-17-001A. (Section 04 – Driveline/Axle). Condition Some customers may comment on a noise or vibration that can be heard centered at or around 2100 RPM. This usually occurs at about 120 km/h (75 mph) in 4th gear, but the sound may be audible in all gears when at 2100 RPM. Cause
Filed Under (Buick) by admin on 14-11-2010
Steering Vibration/Shudder/Moan During Parking Maneuvers on Dry Pavement (Install Power Steering Pressure (Inlet) and/or Return (Outlet) Hose Assembly) 1995-99 Buick Riviera 1997-2001 Buick Park Avenue, Ultra 2000-2001 Buick LeSabre 2000-2001 Pontiac Bonneville steering vibration, shudder or moan noise when steering during parking maneuvers on dry pavement. Correction Install a new power steering pressure (inlet) hose assembly on the following vehicles: • 1995-98 Buick Riviera • 1997-98 Buick Park Avenue and Ultra Install a new power steering pressure (inlet) and return (outlet) hose assembly on the following vehicles: • 1999 Buick Riviera • 1999-2001 Buick Park Avenue and Ultra • 2000-2001 Buick LeSabre • 2000-2001 Pontiac Bonneville 1. Verify that the power steering pump reservoir is full. • If fluid level is low, fill and check for leaks. • If power steering system has air in the system, perform the “Bleeding Air from Power Steering System” procedure as described in the Power Steering System sub-section of the Service Manual. Important: When performing the “Bleeding Air from Power Steering System” procedure, it is important that the front of the vehicle is supported by the lower control arms. If the vehicle is not supported by the lower control arms, the procedure may cause the strut bushing to dislocate and cause new concern. Verify that the accessory drive belt is in good condition and that the pulleys are not bent or damaged. Verify proper belt tension and operation of the belt tensioner. Check for power steering hose ground out conditions. Check for good engine idle and correct engine RPM. Check to see that the rear transaxle mount does not have a plastic assembly aid installed which is used 2. 3. 4. 5. 6.
Filed Under (Saturn) by admin on 01-10-2010
Automatic Transaxle 2-3 Shift Flare During First Minutes of Driving After Cold Soak (Perform Bulletin Procedure) Models: 2002 Saturn S-Series Vehicles with Automatic Transaxle (RPOs MP6, MP7) Attention: General Manager, Fixed Operations Manager, Parts Manager, Technician Condition: Some customers of 2002 S-series vehicles with MP6 or MP7 automatic transaxles may comment on a 2-3 shift flare during the first few minutes of driving after vehicle cold soak. Cause: This condition may be caused by improper pressure, a leak in the 2nd clutch circuit, improper clutch plate finish on 2nd and 3rd clutches, a restriction in the 3rd clutch oil delivery path in the end cover, or improper surface finish in the piston bores of the 2-3 clutch housing. Correction: To correct this condition, duplicate by cold soaking the vehicle the amount of time at temperature described by the owner. Refer to procedure in this bulletin. Service Procedure Verify proper transaxle pressures by installing gauge and performing stepped pressure test after cold soak. Refer to “Stepped Pressure Test” procedure in the 2002 Saturn S-Series Automatic Transaxle Service Manual. ^ If pressures are low, follow the diagnostic chart for DTC P0745 for possible causes of low pressure. Refer to “P0745 – PC Solenoid Pressure Low” diagnostic in the 2002 Saturn S-Series Automatic Transaxle Service Manual. ^ If pressures are within normal ranges, proceed to Step 2. Remove the transaxle end cover. Refer to “End Cover Replacement” in the 2002 Saturn S-Series Automatic Transaxle Service Manual. Check torque on input shaft nut and end cover 3rd clutch oil passage for restrictions. ^ Input shaft nut torque should be 150 N.m (111 ft-lb). If nut is found to be loose, remove nut, clean threads and install new nut using Service Manual procedures and proceed to check 3rd oil passage. ^ Check 3rd oil passage in the end cover by pouring transaxle fluid through it and another passage. If the passage is restricted, you will notice significantly less fluid flow through it. If 3rd clutch passage is found to be restricted, install new end cover per Service Manual procedures and retest for concern. ^ If nut and 3rd clutch passage are okay, proceed to Step 4. Remove transaxle from vehicle. Refer to “Transaxle Removal” in the 2002 Saturn S-Series Automatic Transaxle Service Manual. Disassemble transaxle and install new 2-3 clutch housing, clutch pistons and clutch plates. Refer to “Transaxle Disassemble” in the 2002 Saturn S-Series Automatic Transaxle Service Manual.
Filed Under (Audi) by admin on 15-09-2009
Check the following wire connection for open circuit according to wiring diagram:Relay carrier in E-box, plenum chamber, position 3Terminal Harness connector atignition coils Terminal 8 1 Specified value: Wire resistance max 1.5 – If necessary, repair wire connection. Audi A4 Sedan 2002-2004, Audi A4 Avant 2002-2004, Audi A4 Cabriolet 2003-2004 – 1.8 Liter 4-Cyl. 5V Turbo Generic Scan Tool, Engi…Page 5 24-158 If no malfunctions are found in wires: – Check voltage supply of Motronic Engine Control Module (ECM) voltage supply relay – J271 – Page 24-158 . – Check activation of Motronic Engine Control
Module (ECM) voltage supply relay – J271 – Page 24-159 . Checking voltage supply If specified value is not obtained:
- Connect multimeter for voltage measurement as follows. Relay carrier in E-box, plenum chamber, position 3
Filed Under (Buick) by admin on 15-10-2009
On May 2007, the division of General Motors launched its new SUV model for 2008, the Buick Enclave. Buick Enclave is a full-size luxury crossover SUV. It is partially based on the Buick Centieme shown at the 2003 Detroit Auto Show. It has the same feature as the new GM Lambda platform, just like GMC Acadia, Chevrolet Traverse and Saturn Outlook. The Enclave replaced Buick’s SUVs such as the minivan-based Rendezvous, the truck-based Rainer, as well as the Terraza minivan.
Buick Enclave shares the same platform and mechanical underpinning with the Saturn Outlook, GMC Acadia and Chevrolet Traverse. It comes with a standard front-wheel drive with an option of all wheel drive. The Enclave has a seating capacity for at least seven passengers, with an optional second row bench seat instead of the standard chairs which increases the seating capacity to eigh