97 nissan serena


You are searching repair manual in PDF format about 97 nissan serena use another keyword for search another post or files



  97 nissan serena Direct Download speed 5787 Kb/s

  97 nissan serena Full Version speed 6767 Kb/s




2005 – 2009 Nissan FRONTIER, Nissan XTERRA, Nissan PATHFINDER, FRONT AIR BAG CRASH ZONE SENSOR

0

Filed Under (Nissan) by admin on 04-01-2011

download
SERVICE PROCEDURE 1. Set the parking brake. 2. Connect C-III to the vehicle. 3. Use C-III to check for Air Bag DTCs. a. Navigate C-III to Air Bag Direct Diagnostic Mode. b. Make sure to check both SELF DIAG RESULTS and SELF-DIAG [PAST]. • SELF-DIAG [PAST] is under Special function. • If there are any DTCs stored for AIR BAG other than B1033, B1034 and/or B1035, perform repairs as needed, and then erase DTC before continuing with this procedure. • Diagnosis and repair for DTCs other than B1033, B1034, and/or B1035 is not covered by this bulletin. NOTE: All DTCs (except B1033, B1034, and B1035) must be repaired and erased before continuing with this procedure. 4. Disconnect C-III from the vehicle. 5. Start the engine and let it idle for about 5 seconds. 6. Turn the ignition OFF. 7. WARNING: Prep the vehicle for Crash Zone Sensor replacement as follows: The following are VERY IMPORTANT to prevent unexpected air bag deployment. • Remove the ignition key / Intelligent Key from the cabin of the vehicle and set aside, away from the vehicle (this will prevent accidentally turning the ignition ON). • Make sure the ignition remains OFF until after the new sensor is completely installed. • Make sure no one is in the vehicle cabin and no one enters the vehicle cabin until after the sensor is completely installed. • Wait for all control units to “power down” (at least 1 minute) before continuing. 8. Locate the Crash Zone Sensor (see Figure 2). Crash Zone Sensor Cover 9. Remove the 2 Crash Zone Sensor nuts shown in Figure 3. • Discard these nuts. They will not be reused. 10. Remove the Crash Zone Sensor Cover. 11. Disconnect the electrical connector shown in Figure 4.

Related entry:

diagram of nissan HB12 carburetor control unit, 2001 Nissan pathfinder will not idle after replacing battery, nissan serena c25 service manual, reset bcm 2000 maxima, 2005 nissan ud 1400 fuel filter change, procedure for changing nissan wingroad ECU, how to replace a nissan serena c25 camshaft sensor, abay e25 nissan full gasket set, AIRBAG LIGHT IS BLINKING ON NISAN TIIDA WHAT IS WRONG, AIRBAG LIGHT ON NISSAN TIIDA IS BLINKING WHAT IS WRONG,

NISSAN PERIODIC MAINTENANCE SCHEDULE NISSAN MICRA

0

Filed Under (Nissan) by admin on 11-04-2010

download
ENGINE MAINTENANCE (Petrol Engine) Replace engine oil Replace engine oil filter Inspect drive belts Inspect cooling system
Page 1© NISSAN NISSAN PERIODI CMAINTENANCE SCHEDULE NISSAN MICRA 15,000 KM Inspect brake, clutch and automatic
trans-axle fluids Inspect manual trans-axle gear oil Inspect power steering fluid and lines Inspect brake, clutch and exhaust systems
Inspect steering gear and linkage, axle and suspension parts and front driveshafts Inspect wheel alignment (if necessary rotate
tyres and balance Inspect brake pads, rotors and other brake components Inspect brake linings, drums and other brake
components Inspect foot brake, parking brake and clutch Lubricate locks, hinges & hood latch Inspect seat belts, buckles, retractors,
anchors & adjuster Clean or replace ventilation filter Replace brake fluid (Severe conditions only)

Related entry:

NISSAN MICRA 1 2 2007 SERVICE SCHEDULE, intelligent key for y11 wingroad 2004 make, nissan micra bcm repairs, replacing micra aerial, Torque Settings for micra k12 cylinder head bolts, WHAT TIP OF ENGINE OIL FOR 1500CC NISSAN WINGROAD Y12, wire colors for nissan cigarette lighter,

2004 Nissan 350Z Navigation Guide

0

Filed Under (Nissan) by admin on 20-10-2009

Page 1 Thank you for purchasing an NISSAN automo- bile. This user’s manual is for the navigation system only. This manual contains operating
instructions for the NISSAN Navigation System offered in the NISSAN 350Z. Please read this manual carefully to ensure safe
operation of the navigation system. ? Please read your vehicle’s owner’s manual first. ? Do not remove this manual from the vehicle when selling this vehicle. The next user of this navigation system may need the manual. ? Because of possible specification changes, sections of this manual may not apply to your vehicle. ? All information, specifications and illustra- tions in this manual are those in effect at the time of printing. NISSAN reserves the right to change specifications or design at any time without notice. Page 2 Page 3 CONTENTS INTRODUCTION …………………………………………………………………… 1-1 HOW DOES THE NISSAN NAVIGATION SYSTEM WORK?……………………….. 2-1 WHAT FEATURES ARE AVAILABLE ON THE NISSAN NAVIGATION SYSTEM? …. 3-1 HOW DO I OPERATE THE NISSAN NAVIGATION SYSTEM? …………………….. 4-1 HOW DO I PROGRAM A DESTINATION?…………………………………………. 5-1 HOW DO I USE THE POINT OF INTEREST (POI) FEATURE? ……………………. 6-1 HOW DO I USE THE ADDRESS BOOK FEATURE?……………………………….. 7-1 HOW DO I USE THE AVOID AREA FEATURE? …………………………………… 8-1 HOW DO I USE THE AUTOMATIC REROUTING FEATURE? ……………………… 9-1 HOW DO I USE THE VOICE GUIDANCE FEATURE?…………………………….. 10-1
HOW DO I ADJUST THE DISPLAY? …………………………………………….. 11-1 HOW DO I USE THE VEHICLE INFORMATION? ………………………………… 12-1 INFORMATION ON MAP DATA DISCS………………………………………….. 13-1 TROUBLESHOOTING GUIDE …………………………………………………….. 14-1 INDEX ……………………………………………………………………………. 15-

download

Related entry:

nissan wingroad y12 manual, 5 speed nissan 1400 gearbox manual, Nissan E25 Caravan, nissan wingroad y12 alternator belt adjustment, nissan serena gearbox how does it work, Nissan Teana 230Jk, 14 00 nissan bakkie wiring diagram, nissan wingroad y12 oil and filter, replasing clutch cable on nissan 1400 bakkie, schematicfor370zconvertbletop,

2000-2007 Nissan Pick-up/ Nissan Navara (D22) 2,5D Di Valve timing procedures

0

Filed Under (Nissan) by admin on 07-06-2010

download
Removal/refitting requires: Engine removal. NOTE: Refer to Technical Data module for tightening torques. Sump removal. Align coloured chain links with timing mark on each sprocket [1], [2], [3] & [4] . NOTE: Timing chain marks on injection pump sprocket maybe difficult to see. Remove: Upper timing chain and tensioner. Lower timing chain tensioner. Injection pump sprocket and timing chain. Refit: Ensure crankshaft sprocket keyway at 12 o’clock position [5] . Install injection pump sprocket and timing chain. Insert injection pump sprocket locking tool [6] . Tool No.KV11106030. Align blue or silver coloured chain link with injection pump sprocket timing mark [2] . Align yellow coloured chain link with crankshaft sprocket timing mark [4] . Align blue or silver coloured chain links with timing mark on each camshaft sprocket [1] . Align yellow coloured chain link with injection pump sprocket timing mark [3] . Reset timing chain tensioners: Push plungers into tensioner housings and lock with retaining clips. Refit timing chain tensioners. Remove retaining clips.

Related entry:

nissan navara spill valve, Nissan 1400 Pick Up, nissan navara code p2135, NISSAN NAVARA 2 5 DCI FUEL DIAGRAM, nissan navara injection pump removal, Restoring and repair to nissan 1400 pick up, nissan patrol 6 cylinder engine faulty timing chain tensioner, nisssan 1400 timing firing order diagram, PRELOAD FRONT AXLE NISSAN D22, remove water pump nissan cd17,

2003 – 2005 Nissan Altima 2004 Nissan Maxima ENGINE IS HARD TO START WHEN WARM

0

Filed Under (Nissan) by admin on 04-06-2010

download
The engine is hard to start when warm, but starts OK when the engine is cold. NOTE: “Hard start” is engine crank time that is longer then 3 seconds. • If you only have DTC P0340, replace only Bank 1 CMP (Camshaft Position) Sensor. • If you only have DTC P0345, replace only Bank 2 CMP (Camshaft Position) Sensor. • If you have both codes, replace both sensors. • For a “hard to start warm” incident, replace both sensors, even if you have no codes. Refer to sections EC and EM in the correct Service Manual for sensor replacement information. If replacement of the sensors does not solve your incident, go back to ASIST for further diagnostic and repair information.

Related entry:

2 5 Nissan Engine cam removal, 2003 NISSAN MAXIMA AIR BAG CODE B1035, how to install an immobilizer on a 2004 NISSAN maxima, how to replace ac compressor pulley 2005 nissan altima, 04 nissan maxima hard start when hot, LOCATION OF THE ECM ON A 2004 NISSAN MAXIMA, location of tmc in 98 altima, remove headlight assembly from 2007 nissan altima, removing 2000 nissan pathfinder ecm, change headlight on 2001 nissan altima,