abs light stays on 2008 chevy equinox


You are searching repair manual in PDF format about abs light stays on 2008 chevy equinox use another keyword for search another post or files



  abs light stays on 2008 chevy equinox Direct Download speed 5787 Kb/s

  abs light stays on 2008 chevy equinox Full Version speed 6767 Kb/s




1995 Honda Accord LX TROUBLE SHOOTING ANTI-LOCK (ABS) WARNING LIGHT

0

Filed Under (Honda) by admin on 15-12-2010

download
NOTE: Diagnostic Trouble Code (DTC) Recognition 1. ABS control unit recognizes system related problems and causes ABS warning light to come on and stay on under any of following conditions: Vehicle is driven with parking brake on longer than 30 seconds. One rear wheel is locked. Wheel speed sensor does not transmit a signal. Vehicle is driven on extremely rough road. Low battery voltage. Operation time of solenoid valves exceeds a specified value and control unit indicates an open circuit in solenoid circuit. Output signals from control unit are not transmitted to solenoid valves. Temporary loss of traction due to excessive cornering speed or starting from stuck condition (mud, snow or sand). 2. If ABS warning light comes on intermittently, use ABS Tester (07HAJ-SG0010B) to confirm problem. See ABS FUNCTION TEST under DIAGNOSIS & TESTING. 3. ABS warning light comes on and trouble code is stored in control unit when insufficient battery voltage exists at control unit. If low battery voltage caused problem, recharge battery and clear trouble code(s). See CLEARING DTCs under SELF-DIAGNOSTICS. ABS Warning Light Does Not Come On If ABS warning light does not come on when ignition is on: Check bulb. Check Yellow wire between fuse No. 1 and instrument cluster. Check Blue/White wire between instrument cluster and control unit. Check control unit ground circuit. ABS Warning Light Stays On Without DTCs If ABS warning light stays on and no DTCs have been stored in control unit, check for following items: Loose or poor control unit connector. Blown ABS fuse No. B2 in underhood fuse/relay box. Open circuit in White/Black wire between ABS fuse No. B2 and control unit. Open circuit in Yellow/Black wire between fuse No. 7 and fail-safe relays. ABS system is okay if ABS warning light goes out after engine is started.

Related entry:

Warning Lights on Caddy Van, abs module on international 8600, Subaru ABS Warning Light, 2006 jeep liberty abs light reset, 1994 lexus es300 how to fix abs modulator repair, ABS FUSE ON A 1994 ES300, audi a8 warning symbols, ml 320 abs pump problem, 2005 camry abs light flashing, 1995 sunfire dash indicator lights,

2008-2009 Pontiac G6 GXP 2008-2009 Pontiac G8 2008-2009 Pontiac Torrent GXP Intake System Throttle Body Spacer installation

0

Filed Under (Pontiac) by admin on 17-08-2010

download
Installation Instructions Part Number 200-630 2008-09 Buick Enclave 2008-09 Chevrolet Equinox Sp. 2008-09 Chevrolet Malibu 2008-09 Chevrolet Traverse 2008-09 GMC Acadia 2008-09 Pontiac G6 GXP 2008-09 Pontiac G8 2008-09 Pontiac Torrent GXP 2008-09 Saturn Outlook 2008-09 Saturn Vue XR 2008-09 Suzuki LX7 3.6L V-6 2. Disconnect the breather hose elbow from the intake tube. Loosen the two hose clamps that secure the intake tube to the throttlebody, and the mass air flow sensor. Remove the air intake tube. 1. Disconnect the negative battery cable! Remove the oil fill cap and set it aside. Lift straight up on the engine beauty cover and set it aside. Reinstall the oil fill cap after the beauty cover has been re- moved to prevent any foreign material from entering the crank- case. 3. Remove the four bolts that secure the throttlebody to the in- take manifold. 5. Install the provided bolts and washers thru the throttlebody and Poweraid Spacer and tighten to the manufacturer’s specifi- cations. 4. Install the Poweraid Spacer between the throttlebody and the intake manifold with the first supplied gasket next to the intake manifold, and the second supplied gasket next to the throttle- body as shown. Make sure the “flow” arrow printed on the spacer is pointing towards the intake manifold. 6. Reinstall the intake tube, tighten the two hose clamps, and reconnect the crankcase breather tube. Reinstall the beauty cover, and oil cap in the reverse order that they were removed. Re-connect the negative battery cable!

Related entry:

toyota noah 2008 english manual, sunroofdrainage tubs 2008cadallic cts, 2005 Pontiac Wave Owners Manual, yhs-opera_14desktop, radio manual for 2004 pontiac trans am, firing order for 2008 mkz with 3 5, replace battery for 2006 pontiac torrent, where is condisation drain tube pontaic turrent, change brakes on 2008 milan, 2008 mazda 6 replacing evaporator,

2007-2008 Pontiac Torrent GM Accessories Headrest DVD System Display Monitor Inoperative (Install Cable Connector Clamps)

0

Filed Under (GM) by admin on 13-06-2010

download
GM Accessories Headrest DVD System Display Monitor Inoperative (Install Cable Connector Clamps) 2004-2007 Buick Rainier 2008 Buick Enclave 2003-2008 Cadillac Escalade Models 2005-2008 Cadillac CTS, SRX, STS 2006-2008 Cadillac DTS 2003-2008 Chevrolet Avalanche, Silverado, Suburban, Tahoe, TrailBlazer Models 2006-2008 Chevrolet Colorado 2007-2008 Chevrolet Equinox, HHR 2003-2008 GMC Envoy Models, Sierra, Yukon Models 2006-2008 GMC Canyon 2007-2008 GMC Acadia 2007-2008 Pontiac Torrent 2005-2008 HUMMER H2 2006-2008 HUMMER H3 2007-2008 Saturn OUTLOOK 2005-2008 Saab 9-7X Condition Some customers may comment on an inoperative display monitor or monitors in the GM Accessories Headrest DVD System. Cause This condition may be caused by a loose connection at the display monitor cable connectors. These connectors are located at the lower rear part of both front seats. Two cables are routed to the display monitor in each seat.

Related entry:

2008 avalanche # 4 piston missfire, 2008 cadillac cts sunroof adjustment, instructions to remove engine from 2008 Cadillac SRX, 2008 Cadillac DTS Headlight Removal, how to remove headlight cover 2008 dts, #4 LEAKING CYLINDER ON A 2008 AVALANCHE TRUCK, how do you remove headliner in cadillac cts, How many bolts hold in a 2007 Cadillac dts headlight?, how to change temperature from celcius to fahrenheit on 2008 GM outlook, impala cam bolt installion,

Troubleshooting Anti-lock Brake System (ABS) Indicator Light

0

Filed Under (repair and maintenance tips) by admin on 24-06-2010

download
Temporary Driving Conditions: 1. The ABS indicator light comes on and the ABS con- trol unit memorizes the diagnostic trouble code (DTC) under certain conditions. NOTE: The DTCs are explained on page 19-56. • The tire(s) adhesion is lost due to excessive cor- nering speed. DTC: 5, 5-4, 5-8. • The vehicle loses traction when starting from a stuck condition on a muddy, snowy, or sandy road. DTC: 4-1, 4-2, 4-4, 4-8. • When the parking brake is applied for more than 30 seconds while the vehicle is being driven. DTC: 2-1. • The vehicle is driven on an extremely rough road. The ABS is OK, if the ABS indicator light goes off after the engine is restarted.

Related entry:

2010 mazda 3 security indicator light after tire change, 2010 mazda 3 security indicator ligh after tire change, 2010mazda 3 security indicator light,

2007-2008 Ford Explorer Sport Trac SPARK PLUG REMOVAL INSTRUCTIONS

0

Filed Under (Ford) by admin on 07-09-2010

download
FORD: 2005-2008 Mustang 2004-2008 F-150 2005 Excursion 2005-2008 Expedition, F-Super Duty 2006-2008 Explorer, F-53 Motorhome Chassis 2007-2008 Explorer Sport Trac This article supersedes TSB 08-1-9 to update Vehicle Applications, Service Procedure and Part List. ISSUE Some 2004-2008 F-150, 2006-2008 Mark LT, 2005-2008 F-Super Duty, Expedition, Navigator and 2005 Excursion, with 5.4L 3-V engine; 2005-2008 Mustang, 2006-2008 Explorer, Mountaineer, and 2007-2008 Explorer Sport Trac with 4.6L 3-V engine; 2005-2008 F-Super Duty, 2006-2008 F-Stripped Chassis, and 2005 Excursion, with 6.8L 3-V engine may experience difficulty with spark plug removal. This may cause damage to the spark plug and leave part of the spark plug in the cylinder head. Affected engine build dates are as follows: 5.4L 3-V and 6.8L 3-V before 10/9/07, 4.6L 3-V before 11/30/07. ACTION Refer to the following Service Procedure for techniques to remove the spark plugs and extract broken spark plugs. SERVICE PROCEDURE The engine build date can be read on the left hand cam cover information sticker. To remove spark plugs without damage, it is necessary to adhere exactly to this procedure before removal is attempted. LINCOLN: 2005-2008 Navigator 2006-2008 Mark LT MERCURY: 2006-2008 Mountaineer

Related entry:

2008 jeep patriot alternator location, ford edge vista roof diagram, 2007 explorer grill remove, FORD EXPLORER 2008 LIGHTS FOR GEAR SHIFT, ford focus idle vibration 2008, Ford Edge Owners Manual 2008, ford edge 3 5 engine firing order, Ford 3 5 Firing Order, FIRING ORDER 2008 FORDEDGE, diagram heater hose on 2008 ford expe,