Filed Under (Chevrolet) by admin on 02-05-2010
download
OVERHAUL – 4L60-E Fig. 16: Exploded View Of 4L60-E Transmission Internal
Components GENERAL MOTORS CORP.
1995 Chevrolet Chevy Van G20
s p o n s o r e d l i n k s
Filed Under (Toyota) by admin on 02-05-2010
download
Fig. 14 Exploded View Of Disc Brake Assembly 5 Exploded View Of Disc Brake Assembly. 1989 Celica w/AWD 16 Exploded View Of Disc Brake Assembly. 1990 Celica NOTE: If a squealing noise occurs from the front brakes while driving, check the pad
wear indicator. If there are traces of the indicator contacting the rotor disc, the brake pad
should be replaced.
z Remove front wheel
z Temporarily fasten the rotor disc with the hub nuts.
z Inspect pad lining thickness
Filed Under (Ford) by admin on 02-05-2010
download
REMOVAL AND INSTALLATION Exterior Mirrors — Exploded View Printable View (364 KB) Aero-Style Mirror
NOTE: LH exterior mirror shown, RH exterior mirror similar. 14631 Exterior mirror electrical connector W705760 Exterior mirror nut (3 required) 17K707 Exterior mirror glass — Dampener springs (part of 17K707) Exterior mirror motor screw (3 required) (part of 17D696)
17D696 Exterior mirror motor — Exterior mirror lower cover screw (3 required) (part of 17682 RH/ 17683 LH) — Exterior mirror lower cover (part of 17682 RH/ 17683 LH) 17D742 RH/ 17D743 LH Exterior mirror upper 17682 RH/ 17683 Exterior mirror
Filed Under (Toyota) by admin on 30-04-2010
download
EGR Vacuum Modulator Bracket Suction Chamber Suction Piston Throttle Positioner
? Non-reusable part Throttle Solenoid Actuator Carburetor – Exploded View
Filed Under (Subaru) by admin on 26-04-2010
download
Exploded View Of Rear Suspension Assembly.1. Remove rear seat cushion and backrest. 2. Raise and support vehicle. 3. Remove rear wheels. 4. Disconnect brake hose from brake caliper. 5. Remove lower and upper strut mount retaining bolts, then the strut assembly. 6. Mount strut assembly in a suitable spring compressor. Ensure projections on compressor are seated on inner diameter of spring. 7. Compress spring until tension is relieved from spring seats. 8. Remove strut rod self-locking nut using a suitable socket wrench and spanner wrench tool No. 926510000 or equivalent. 9. Remove upper strut mount. 10. Slowly release spring tension, then remove coil spring, dust cover and helper from strut body. 11. Reverse procedure to install, noting the following: a. Mount coil spring with flat face toward lower spring seat. b. Use caution not to scratch piston rod. c. Install strut rod with new locking nut.
d. Refer to Figs. 7 and 8 for torque values. e. Bleed brake hydraulic system. Pneumatic Suspension
