Filed Under (Mercury) by admin on 15-05-2010
download
FORD: 2001-2004 Taurus MERCURY: 2001-2004 Sable This article supersedes TSB 03-15-06 to update the vehicle model years and build date information. ISSUE Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the blower case or on the passenger side floor, an inoperative climate control blower motor, a motor that operates on high speed only, and/or a blower motor resistor failure. ACTION Inspect and seal cowl area and install Rain-Hat Extension Seal. Inspect and replace blower motor and/or blower motor resistor if there is evidence of water/corrosion. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
Filed Under (Ford) by admin on 26-04-2010
download
FORD: 2001-2004 Taurus MERCURY: 2001-2004 Sable This article supersedes TSB 03-15-06 to update the vehicle model years and build date information. ISSUE Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the
blower case or on the passenger side floor, an inoperative climate control blower motor, a motor that operates on high speed only, and/or a blower motor resistor failure.
ACTION Inspect and seal cowl area and install Rain-Hat Extension Seal. Inspect and replace blower motor and/or blower motor resistor if there is evidence of water/corrosion. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
Filed Under (Ford) by admin on 16-05-2010
download
1 Disconnect the blower motor resistor electrical connector. 2 Remove the screws and the blower motor resistor. 3. To install, reverse the removal procedure. BLOWER MOTOR RESISTOR
Removal and Installation Zoom Sized for Print 1. Remove the RH quarter trim panel access panel.
Filed Under (Ford) by admin on 15-05-2010
download
Removal and Installation 1. Lower the glove compartment. 2. Disconnect the blower motor resistor electrical connector. 3. Remove the 2 blower motor resistor screws. 4. Remove the blower motor resistor. 5. To install, reverse the removal procedure. Heating and Air Conditioning Blower Motor Resistor
Service and Repair
Filed Under (Chevrolet) by admin on 25-01-2011
download
1. Disconnect the electrical connector (3). 2. Remove the blower motor resistor mounting screws (1). 3. Remove the blower motor resistor (2) from the blower case. 2. Install the blower motor resistor mounting screws (1). Tighten Tighten the screws to 1.9 N.m (17 lb in). 3. Connect the electrical connector (3). Removal Procedure (C60) 1. 2. 3. 4. 5. Remove the A/C control relay bracket with the relay. Remove the blower resistor harness. Remove the stud from the IP, if necessary. Remove the blower motor resistor mounting screw. Cut the access cover from the case. Cut all four sides of the cover in order to remove the three attaching screws. Use a sharp utility knife in order to cut the case. Make the cuts straight and clean. The access cover must be reinstalled and is visible to the customer.
