Filed Under (Subaru) by admin on 26-04-2010
download
2002 Subaru Impreza RS WIRING DIAGRAMS Fig. 8: Wiring Diagram (Impreza 2.5L & Outback Sport 2.5L – 1 Of 3)
s p o n s o r e d l i n k s
Page 1 CHART EXPLANATION B- 12 voltignition U- 12 volt battery E- ECU Ground P- Pressure sensor, Air flow signal
(Note: some applications have multiple “P” signals-Use P(AFR) for AFR and P(FCD) for FCD) I- RPM signal S- Speed Sensor T- Throttle Position Sensor
#- Injector Signal * ALL DIAGRAMS ARE SHOWN FROM THE WIRE SIDE OF THE HARNESS FORD FOCUS ZX3 2000-2003 2.0L ZETEC (DOHC)
ECU LOCATION-4 Hot Wire (0-5V) HONDA / ACURA ACURA RSX/HONDA CIVIC SI 2002-2004 K20A2 ECU LOCATION-3 Pressure Sensor Type HONDA CIVIC 1988-1991 ACURA INTEGRA 1986-1993
The following diagrams may differ slightly depending on vehicle year, or model (California or Federal). Confirm that the diagram shown
corresponds to your vehicle by referencing the factory repair manual. Locate the engine control unit (ECU) using the diagram below.
FORD FOCUS ZX3 2000-2003 2.0L ZETEC (DOHC) ECU HONDA / ACURA ACURA RSX/HONDA CIVIC SI 2002-2004
download
Filed Under (Acura) by admin on 16-10-2009
WIRING INFORMATION 2002 Acura RSX WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT WIRE WHITE Ignition Harness STARTER WIRE BLACK/WHITE Ignition Harness IGNITION WIRE BLACK/YELLOW Ignition Harness SECOND IGNITION WIRE BLACK/RED
Ignition Harnes
Filed Under (Audi) by admin on 15-09-2009
Check the following wire connection for open circuit according to wiring diagram:Relay carrier in E-box, plenum chamber, position 3Terminal Harness connector atignition coils Terminal 8 1 Specified value: Wire resistance max 1.5 – If necessary, repair wire connection. Audi A4 Sedan 2002-2004, Audi A4 Avant 2002-2004, Audi A4 Cabriolet 2003-2004 – 1.8 Liter 4-Cyl. 5V Turbo Generic Scan Tool, Engi…Page 5 24-158 If no malfunctions are found in wires: – Check voltage supply of Motronic Engine Control Module (ECM) voltage supply relay – J271 – Page 24-158 . – Check activation of Motronic Engine Control
Module (ECM) voltage supply relay – J271 – Page 24-159 . Checking voltage supply If specified value is not obtained:
- Connect multimeter for voltage measurement as follows. Relay carrier in E-box, plenum chamber, position 3
Terminal
Filed Under (Toyota) by admin on 19-05-2011
download
Some 2002 – 2004 model year non-PZEV Camry vehicles with the 2AZ–FE engine may experience the following condition: • A rattle noise from the engine area, most noticeable at idle or on light acceleration. The noise may be caused by the intake air as it ?ows through the intake manifold. The intake manifold has been modi?ed to improve this condition. Repair Procedure 1. Verify noise is from the intake manifold. 2. Replace the intake manifold. Refer to the Technical Information System (TIS): • 2002 / 2003 model year Camry Repair Manual, Engine/Hybrid System – Engine Mechanical – “Cylinder Head Gasket (2AZ-FE): Replacement”. • 2004 model year Camry Repair Manual, Engine/Hybrid System – Engine Mechanical – “Cylinder Head Gasket (2AZ-FE)(from July, 2003): Replacement”. 3. Verify that the noise is NOT present after repair.
