You are searching repair manual in PDF format about previa sunroof use another keyword for search another post or files
previa sunroof Direct Download speed 5787 Kb/s
previa sunroof Full Version speed 6767 Kb/s
Filed Under (Vauxhall) by admin on 06-06-2011
Keys, doors, windows, sunroof To raise Turn the rotary switch to any position between d and e. The sunroof w ill automatic ally move to the desired position. When the rotary switch is in position e, the sunroof is fully raised. To lower Turn rotary switch to d. Posit ion memory After the ignition has been switched on, the sunroof c an be automatically returned to its last position b y briefly pressing the rotary switch. Safety function If the sunroof encounters resistance during automatic closing, it is immediately stopped and opened again, as long as the vehicle is stationary. Operated using rotary switch in the overhead control panel. To open Turn the rotary switch to any position between d and ü. The sunroof will automatically move to the desired position. When the switch is in position ü , the sunroof is fully opened . Com fort position Set rotary switch to position f. With the roof in this position, w ind noise is reduced. To close: Turn rotary switch to d. 9 Warning Closing sunroof from outside To close the sunroof from outside with the remote control: Press button p until the sunroof is closed. If the electric windows 3 are to be closed from outside the vehicle, but the sunroof is to be left op en, briefly press the rotary switch before switching off the ignition. Automatic closing 3 See page 33. If when the vehicle is being driven the sunroof encounters resistance during automatic closing, because of the higher closing forces involved the protective function cannot be guaranteed, and there is a risk of injury. If the sunroof movement is stiff, e.g. due to frost, turn rotary switch to d and keep it pressed until the sunroof is closed. Keys, doors, windows, sunroof Sunshade To reduce the sunlight in the interior with the sliding roof closed or raised. O pen or close sunshade as required. When the sunroof is opened, the sunshade is also opened. Overload If the sy stem is overloaded, the power sup ply is automatically cut off for a short time. Fault If the sunroof no longer assumes the desired position automatically , programm e sunroof electronics as follow s: 1. Switch on ignition. 2. Press the rotary switch until the sunroof is shut, then keep it pressed for a t least a further 3 seconds. 3. Turn rotary switch to ü and keep it depressed until the sunroof is open. 4. Turn rotary switch to d and keep it depressed until the sunroof is closed . 5. Turn rotary switch to e and leave there until the sunroof is fully raised. 6. Turn rotary switch to d and keep it depressed until the sunroof is closed . Electrically operated rear window blind 3 Reduces intensity of sunlight shining on to rear seats. Operation w ith ignition switched on. To raise To lower = = Do not operate blind if there are objects lying in front of the rear window. Sun blinds for rear door windows 3 To reduce sunlight a t the rear seats. Pull the blind upwards using the grip and engage it at the top in the door frame. Press N Press N again
Filed Under (Chrysler) by admin on 09-12-2010
SYMPTOM/CONDITION: DIAGNOSIS: 1. Verify the rear of the sunroof glass to roof flushness concern. 2. UNCALIBRATE THE SUNROOF. a. b. c. d. e. 3. RECALIBRATE THE SUNROOF a. b. c. 4. If the uncalibrate/recalibrate procedure did not eliminate the sunroof glass to roof fit, use the procedures outlined in TechCONNECT(R) BODY/SUNROOF/GLASS PANEL/ADJUSTMENTS to adjust the glass panel. If the sunroof glass is now flush, perform the Repair Procedure. If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure. Insure the battery is at least 12 Volts. Place the ignition switch in RUN position. Locate the sunroof fuse (Fuse 44 in the Power Distribution Center located in the trunk). While the sunroof is still in motion, have an assistant remove the sunroof fuse. Reinstall the sunroof fuse. Press and hold the sunroof vent switch until it stops at the full vent position. Verify sunroof operation by opening, closing, and venting the sunroof. If the uncalibrate/recalibrate procedure corrected the sunroof glass to roof fit, perform the Repair Procedure.
Filed Under (Toyota) by admin on 17-12-2015
Toyota Previa & Estima
1990 TO 2000
Service and Repair Manual on CD
This, Toyota Previa/Estime, service and repair manual, covers all aspects of maintaining and repairing your vehicle which is NOT contained in the user manual
This manual covers BOTH the UK and Japanese model
Estima Lucida 2.2 diesel and 2.4 petrol
Estima Emina 2.2 diesel and 2.4 petrol
Previa 2.2 diesel and 2.4 petrol
It covers the 3C-T and 3C-TE diesel engines, and the 2.4 petrol engine.
To include: Maintenance of the manual and automatic gearboxes
Filed Under (Saturn) by admin on 27-06-2010
Certain 2008 model year Buick Enclave; 2007-2008 model year GMC Acadia and Saturn OUTLOOK vehicles equipped with a sunroof may have a condition in which water is not properly drained away from the sunroof. If this condition were to occur, water may enter the interior of the vehicle and dampen the carpet, upholstery, and other interior components. Correction Dealers/retailers are to install drain tube extension assemblies, and ensure that the water drains properly
Filed Under (Toyota) by admin on 31-01-2016
Subject : Handling of DTC “P0420/P0430″ Case by Models This service bulletin is to inform you on how to handle “DTC P0420 / P0430″ cases for Yaris, Previa / Tarago, RAV4, Avensis Verso / Picnic. DESCRIPTION OF PHENOMENON • Engine MIL ON.
• Code P0420 or P0430 in the engine ECU. • No influence on driveability or engine performance.
PRODUCTION IMPROVEMENT Yaris: Modified Engine ECU software RAV4: Modified Engine ECU software and modified catalyst coating
Avensis Verso: Modified Engine ECU software and modified catalyst coating Previa: Modified Engine ECU software and modified catalyst coating