sonata wiring diagram
You are searching repair manual in PDF format about sonata wiring diagram use another keyword for search another post or files
sonata wiring diagram Direct Download speed 5787 Kb/s
sonata wiring diagram Full Version speed 6767 Kb/s
Filed Under (Toyota) by admin on 28-09-2009
ELECTRICAL WIRING DIAGRAM
This Service Bulletin is to inform you of the Electrical Wiring Diagram for RAV4 equipped with 1CD-
FTV engine.RELAY LOCATIONS ELECTRICAL WIRING ROUTING OVERALL ELECTRICAL WIRING DIAGRAM CONNECTOR JOINING WIRE HARNESS AND WIRE HARNESS
Filed Under (Chevrolet) by admin on 19-03-2011
DEFOGGERS Fig. 1: Defogger Circuit HORN Fig. 2: Horn Circuit POWER ANTENNA Fig. 3: Power Antenna Circuit POWER DOOR LOCKS Fig. 4: Power Door Lock Circuit POWER SEATS Fig. 5: Power Seat Circuits POWER WINDOWS Fig. 6: Power Window Circuit, 2 Door RADIO Fig. 7: Mono Radio Circuit Fig. 8: Stereo Radio Circuit STARTING/CHARGING Fig. 9: Charging Circuit Fig. 10: Starting Circuit TRUNK, TAILGATE, FUEL DOOR Fig. 11: Trunk Release Circuit WIPER/WASHER Fig. 12: 2-Speed Wiper/Washer Circuit Fig. 13: Interval Wiper/Washer Circuit PART 2 Fig. 1: Engine Compartment Fig. 2: Engine Compartment (Cont.) Fig. 3: Fuse Block & Underdash Fig. 4: Underdash (Cont.) & Instrument Panel Fig. 5: Instrument Panel (Cont.) Fig. 6: Rear Compartment & Accessories SUB-SYSTEM WIRING DIAGRAMS CANADIAN MODELS Fig. 7: Kicker System Wiring Diagram (5.0L “B” Body A/C) Fig. 8: A/C Kicker System (3.8L “B” & “G” Body) Wiring Diagram Fig. 9: Electric Choke Heater (3.8L “B” & “G” Body) Wiring Diagram Fig. 10: Electric Choke Heater (3.8L “B” Body Without Gauges) Fig. 11: Electric Choke Heater (5.0L “B” & “G” Body) Fig. 12: Early Fuel Evap System (“B” & “G” Body) Wiring Diagram Fig. 13: TCC (“B” & “G” Body, 3 or 4-Speed Auto. Trans.)
Filed Under (Hyundai) by admin on 25-11-2010
Santa Fe (2.7L) & Sonata (2.5L) 1. Turn ignition off. Disconnect TP sensor 3-pin connector. Measure resistance between TP sensor terminals No. 2 (Orange wire on Santa Fe, Black/White wire on Sonata) and No. 1 (Yellow/Black wire on Santa Fe, Green/White wire on Sonata). See Fig. 1 . Standard resistance value should be 3500-6500 ohms. If resistance is not as specified, replace TP sensor. If resistance is as specified, go to next step. 2. Measure resistance between TP sensor terminals No. 2 (Orange wire on Santa Fe, Black/White wire on Sonata) and No. 3 (Red/Orange on Santa Fe, Blue wire on Sonata). Open throttle slowly from idle position to wide-open throttle position. Resistance should change smoothly in proportion to the throttle valve opening. If resistance changes smoothly, go to next step. If resistance does not change smoothly, replace TP sensor. 3. Reconnect TP sensor connector. Using a voltmeter, backprobe sensor connector terminals No. 1 (Yellow/Black wire on Santa Fe, Green/White wire on Sonata) and No. 3 (Red/Orange on Santa Fe, Blue wire on Sonata). Turn ignition on, and measure TP sensor voltage. Voltage should be 250-800 millivolts. If voltage is not as specified, replace TP sensor.
Filed Under (volkswagen) by admin on 10-08-2010
NOTE: Wiring Diagrams are classified by OE as belonging to one of three categories. These Three OE Categories Are:: 1 – Standard Equipment 2 – Engine Specific 3 – System Specific and Optional Equipment Presents These Three Categories As Follows: Standard Equipment This category includes equipment such as Instrument Cluster and Gauges, Headlights/Tail Lights/Turn Signals, Rear Window Defroster, Wipers and Washers, etc.. Standard equipment is found on all vehicles regardless of which engine or optional equipment is installed. The Standard Equipment diagrams can be found at Power and Ground Distribution diagrams. These diagrams have a hyperlinked Wiring Diagram Index that lists all of the components shown within them. Click on the link for the component in question, and the link will take you to the first appropriate diagram with that component’s circuit. Engine Specific This category includes components and systems circuits such as Starting and Charging Systems, Engine Controls, Ignition System, Fuel Injection System, etc., which are unique to a specific engine. The Engine Specific diagrams can be found at Powertrain Management diagrams. These diagrams have a hyperlinked Wiring Diagram Index that lists all of the components shown within them. Click on the link for the component in question, and the link will take you to the first appropriate diagram with that component’s circuit. System Specific and Optional Equipment This category includes equipment such as Air Bag Systems, Anti-lock Brake System, Heated Seats, HVAC System, Comfort System, etc. and provides circuit details for those systems and components
Filed Under (Hyundai) by admin on 16-03-2011
DESCRIPTION: On some vehicles the ambient temperature displayed on the climate controller may differ from the actual outside temperature by more than 5-10oF. An updated ambient temperature sensor is available to improve this condition. This TSB provides the procedure to install the updated ambient temperature sensor located in front of the radiator/condenser. • Model / Affected vehicle production date range: • Azera (TG): Produced Job #1 – January 8, 2006 • Sonata (NF): Produced Job #1 – January 8, 2006 REPLACEMENT PROCEDURE: 1. Unfasten the ambient temperature sensor mounting bolt. 2. Remove the ambient temperature sensor by disconnecting the wiring connector. 3. Connect the wiring connector to the new sensor. 4. Tighten the ambient temperature sensor mounting bolt. 5. Reset the A/C control head after ambient temperature sensor replacement. • Azera – Remove for 15 seconds the Power Connector Fuse (30 amp) from the passenger compartment junction block and replace. • Sonata – Remove for 15 seconds the Power Connector 2 Fuse (15 amp) from the passenger compartment junction block and replace.