vw lt 45 ignition relay


You are searching repair manual in PDF format about vw lt 45 ignition relay use another keyword for search another post or files



  vw lt 45 ignition relay Direct Download speed 5787 Kb/s

  vw lt 45 ignition relay Full Version speed 6767 Kb/s




2001 Volkswagen Jetta GLS Relay location on the thirteen position auxiliary relay panel

0

Filed Under (volkswagen) by admin on 05-11-2010

download
Relay location on the thirteen position auxiliary relay panel, above relay panel: 1 – Auxiliary Emergency Flasher Relay (404) 2 – Relay for Motor Remote Unlock Rear Lid (79) 3 – Starting Interlock Relay (53) (185) (465) 4 – Fog Light Relay (53) 5 – Control Module for Multi-function Steering Wheel (450) 6 – Control Module for Multi-function Steering Wheel (450) 7 – Daytime Running Lights Change-over Relay (173), from April 1999 8 – Daytime Running Lights Change-over Relay (173), through March 1999 9 – Dual Horn Auxiliary Relay (53) 10 – Glow Plug Relay (180) 10 – Warning Lamp Auxiliary Relay (200) 11 – Park/Neutral Position (PNP) Relay (175) 12 – Power Supply (Terminal 30, B+) Relay (109) Relay Panel: 1 – Dual Horn Relay (53) 2 – Load Reduction Relay (18) (100) 4 – Fuel Pump (FP) Relay (409) V – Wiper/Washer Intermittent Relay (192) (377) (389) VI – Wiper/Washer Intermittent Relay (192) (377) (389) NOTE Number in parentheses ( ) indicates production control number stamped on relay housing.

Related entry:

1996 chevy silverado fuse relay center, 1996 chrysler lxi power window fuse and relay locacions, how to take out a abs relay for 1999 bmw 528i, locate feul relay vw microbus 2 6, location of ac relay on 2005 scion tc, seat alhambra relay location, change condensor 2005 saturn relay, 2003 ford windstar abs relay location, 2007 dodge ram a/c condensor fan fuse, 2007 tundra starter location,

1998 Dodge Grand Caravan Fuel Pump Relay test

0

Filed Under (Dodge) by admin on 07-12-2010

download
1. Remove fuel pump relay from power distribution center at driver’s side front corner of engine compartment, near the battery. Note terminal identification on fuel pump relay. See Fig. 6 . 2. To check fuel pump relay resistance, use ohmmeter and check resistance between terminals No. 85 and 86 on fuel pump relay. Replace fuel pump relay if resistance is not 70-80 ohms. 3. To check fuel pump relay operation, connect ohmmeter between terminals No. 30 and 87A on fuel pump relay. See Fig. 6 . Ohmmeter should indicate continuity between terminals No. 30 and 87A on fuel pump relay. 4. Connect ohmmeter between terminals No. 30 and 87 on fuel pump relay. See Fig. 6 . Ohmmeter should indicate no continuity between terminals No. 30 and 87 on fuel pump relay. CAUTION: DO NOT allow ohmmeter leads to contact terminals No. 85 and 86 on fuel pump relay when fuel pump relay is energized. 5. Connect 16-gauge jumper wire between negative battery terminal and terminal No. 85 on fuel pump relay. Connect 16-gauge jumper wire between positive battery terminal and terminal No. 86 on fuel pump relay. 6. Fuel pump relay should now be energized. No continuity should now exist between terminals No. 30 and 87A on fuel pump relay. Continuity should now exist between terminals No. 30 and 87 on fuel pump relay. Disconnect jumper wires. Replace fuel pump relay if defective. 7. If fuel pump relay or wiring circuit failure exists, a Diagnostic Trouble Code (DTC) will be stored in Powertrain Control Module (PCM). See appropriate G – TESTS W/CODES article.

Related entry:

wheres the pump relay on 98 toyota sienna,

1993 Honda Civic del Sol S IGNITION CHECKS ELECTRONIC IGNITION SYSTEM

0

Filed Under (Honda) by admin on 03-01-2011

download
Spark Check for spark at secondary coil wire and each spark plug wire using a spark tester. If spark is not present, continue with following tests. Check spark plug wire resistance on suspect wires. Resistance should be less than 25,000 ohms. Ignition Coil Power Source 1. On Civic, remove distributor cap to check power source directly at coil. On all models, disconnect ignition coil primary leads. Turn ignition on. Using voltmeter, check voltage between ground and Black/Yellow wire terminal of ignition coil harness. 2. Battery voltage should be present. If battery voltage is not present, check for open in Black/Yellow wire between coil and ignition switch. Ignitor Power Source Turn ignition off. Disconnect harness connector at distributor. Turn ignition on. Using voltmeter, check for battery voltage between ground and Black/Yellow wire of harness. If voltage is not present, check for open in Black/Yellow wire between ignition coil and harness connector. If wire is okay, check ignition coil resistance (for internal short to ground). Ignitor Check Check TDC/CRANK/CYL sensor resistance values. See TACH PULSE SIGNAL . Check power sources. If no problems are found and spark is not present, replace ignitor. Ignition Coil Resistance (Accord & Prelude) 1. Remove primary and secondary leads from ignition coil. Using an ohmmeter, check resistance between primary terminals “A” and “C” (“A” and “B” for Prelude) of ignition coil. See Fig. 2 . Resistance should be .6-.8 ohm at room temperature. 2. On Accord, check resistance between terminals “B” and “D” of ignition coil (tachometer circuit). Resistance should be about 2090-2310 ohms at room temperature. 3. On all models, check secondary resistance between terminal “A” and secondary output terminal (coil tower). See IGNITION COIL RESISTANCE table. Check for continuity between terminals “A” and “B” (“A” and “C” for Prelude). Continuity should exist. If readings are not within specification, replace coil.

Related entry:

wiring diagram ignition 1984 vw scirocco, golf ignition module diagram, Ford Ignition Actuator Replacement, firing order for 07 teraza, diagram for coil pack located on 2006 kia sorento, coil pinout voltage opel astra 2001 1208065 diagram, adjust timing 93 volvo 940, 96 kia sportage where does coil pack clips on engine, 92 chevy 1500 distributor module wiring, 80 corvette a/c diagram,

1995 Volvo 960 Component Location Component List

0

Filed Under (Volvo) by admin on 07-08-2010

download
No. 1/1 2/1 2/2 2/4 2/5 2/6 2/7 2/11 2/15 2/16 2/17 2/20 2/22 2/23 2/28 2/30 2/32 2/35 2/44 2/46 2/53 2/61 2/66 3/1 3/2 3/3 3/4 3/6 3/7 Component Name Battery Headlight relay with bulb failure sensor Foglight relay Intermittent wiper relay, windshield wipers Relay, seat belt reminder/ignition key warning Overload relay 15I Central lock relay, inside lighting, delayed action Relay, engine cooling fan Relay exhaust temperature sensor Intermittent wiper relay, tailgate wiper Horn relay Relay auto down power windows Automatic climate control A/C relay Relay, fuel pump Anti-theft relay Overload relay, +X Main relay, Fuel Injection system Start motor 50 relay Relay rear window/door mirror heating Relay ignition coil Air pump relay Parking lights relay Relay, fog lights, USA Ignition lock High and low beam switch Switch, turnsignal/high-low beam Cruise control operation Switch, hazard warning with flasher relay Foglight switch

Related entry:

1975 ford l9000 flasher, ford l9000 flasher,

2001 Jaguar X-TYPE Relay and Fuse Location

0

Filed Under (Jaguar) by admin on 20-11-2010

download
R1 R2 R3 R4 R5 R6 R7 R8 R9 R10 R11 WINDSHIELD WIPER MOTOR RELAY WINDSHIELD HEATER RELAY HORN RELAY ACCESSORY POWER RELAY POWER WASH PUMP RELAY A/C COMPRESSOR CLUTCH RELAY EMS CONTROL RELAY TCM RELAY DIP BEAM RELAY STARTER RELAY THROTTLE MOTOR RELAY R15 R16 R17 R18 R19 R20 R21 MAIN BEAM / FRONT FOG RELAY NOT USED REVERSE LAMPS RELAY IGNITION RELAY HEATED REAR WINDOW RELAY A/C BLOWER RELAY BATTERY SAVER RELAY

Related entry:

x type JAGUAR ems code 1 L1000,