download
1. 2. 3. 4. 5. Open front hood and support with a stay. Disconnect battery cables from battery. Remove air intake duct. Remove clutch cable, return spring and hill-holder cable. Disconnect the following: – - – - Oxygen Sensor connector Crank Angle Sensor connector Cam Angle Sensor connector Knock Sensor connector – - Transmission Harness connectors Transmission Ground Terminal 6. Disconnect start connector and terminal and remove the starter assembly. 7. Remove pitching stopper rod. 8. Remove connector holder bracket.9. Set the engine support assembly (927670000). 10. Remove engine to transmission mounting nut and bolt on the upper side. 11. Raise and support car then disconnect the front exhaust pipe from the engine. Note: Remove all nuts except one. This nut is used to temporarily hold the exhaust pipe. 12. 13. 14. 15. 16. 17. 18. Disconnect the front to rear exhaust pipe connection. Disconnect front exhaust pipe at transmission and hanger locations. Remove the nut which was used to temporarily hold the exhaust pipe in step 11 and disconnect the front exhaust pipe. Disconnect rear exhaust pipe from muffler. Remove front cover of rear differential mount. Remove the four bolts which hold the propeller shaft to rear differential. Remove the two bolts which hold the center bearing to the car body.
Related posts:
- 1996 Subaru Outback [Legacy] FRONT CATALYTIC CONVERTER REMOVAL
- 1991 Subaru Legacy Sedan FUEL PUMP CIRCUIT DIAGNOSTIC CHART
- 1997 Subaru Legacy GT Sedan Timing Belt Service and Repair Installation
- 1998 Subaru Legacy Outback Oil Pan Service and Repair
- 2010 Subaru Legacy / Outback CVT Transmission Fluid Cooler Inlet Hose replacement
