2007 Subaru Legacy F4-2.5L DOHC Turbo – Service and Repair

0

Filed Under (Subaru) by admin on 26-04-2010

download
Cam Sprocket REMOVAL NOTE: Perform the work with the engine installed to body when replacing a single part. 1) Remove the V-belts. 2) Remove the crank pulley. 3) Remove the timing belt cover. 4) Remove the timing belt. 5) Remove the actuator cover of the intake cam sprocket. 6) Fasten the cam sprocket and remove from the cam shaft using ST. ST 499207400 CAM SPROCKET WRENCH INSTALLATION 1) Fasten the cam sprocket and install to the cam shaft using ST. NOTE: Do not confuse the cam sprockets (LH) and (RH) during installation. ST 499207400 CAM SPROCKET WRENCH Tightening torque: Tighten to 30 N-m (3.1 kgf-m, 22.1 ft-lb) of torque, and then tighten further by 45° .

Related entry:

2005 subaru 2 5 dohc turbo camshaft sprocket removal, subaru dohc set cams to neutral,

  2007 Subaru Legacy F4-2.5L DOHC Turbo – Service and Repair Direct Download speed 4887 Kb/s

  2007 Subaru Legacy F4-2.5L DOHC Turbo – Service and Repair Full Version speed 5767 Kb/s

Comments are closed.