Filed Under (Volvo) by admin on 30-08-2010
download
Boot, half shaft, replacing Special tools: 951 2619, 999 2412 Disassembly Note: Preparatory work, see Axle Shaft Assembly; Service and Repair. Remove the boot Secure the drive shaft in a vise with soft jaws. Remove the clamps from the boots. Cut the boot and remove it from the shaft. Check the measurement Wipe off the grease from the constant velocity joint housing. Measure the distance from the inner ring to the inner groove on the shaft. Note the measurement. Tap off the constant velocity joint housing Use a brass drift. Note: Only tap the inner ring. Take care not to damage the ball holder or outer ring. For cleaning/assembly and greasing the outer joint, see below
Filed Under (Volvo) by admin on 08-08-2010
download
Remove three screws. Pull the steering wheel as far out as possible. Remove the clip mounting between the covers. Remove the lower steering column cover. Remove the seal for the clip mounting at the dashboard. Remove the upper steering column cover. Installing Install the lower cover for the steering column. Secure the seals for the switches Install the three screws. Press the seal in towards the dashboard in the upper steering column cover. Press the upper cover into place in the upper cover. NOTE: Check that the seals for the switches are positioned correctly throughout the operation.
Filed Under (Volvo) by admin on 07-08-2010
download
NOTE: Minimum thickness for replacing the brake pads = 3.0 mm . Remove the securing spring and locating pins Remove: the securing spring (3) carefully so that it does not deform the protective caps (1) from the two locating pins (2) the locating pins, use hex socket 7 mm . Remove the brake caliper and brake pads Remove: the brake caliper from the holder the brake pads. Hang brake caliper from a steel wire from the front spring so as not to damage brake hose. NOTE: Do not depress the brake pedal while the brake pads are removed. Clean and check brake caliper and dust cover Brake Pads, Rear, Replacing Removal NOTE: Minimum thickness for replacing the brake pads = 3.0 mm . Remove retaining springs and locating pins for brake pads Remove:
