Filed Under (Daewoo) by admin on 05-04-2011
download
1. Adjust rear brakes. Release parking brake. Raise and support vehicle. Check parking brake cables for free movement. See Fig. 7 . Lower vehicle. Move front seats forward. Pry off plastic caps that cover access holes to parking brake console hood-to-tunnel bracket screws. Unfasten screws that secure parking brake console hood to tunnel brackets. Raise console hood to expose parking brake lever assembly and adjustment nut. See Fig. 8 . 2. Partially raise and support vehicle. Turn adjustment nut on lever assembly until wheels are difficult to turn. Loosen nut until rear wheels are just free to turn. Lower vehicle, position parking brake console hood and fasten it to tunnel brackets with screws. Tighten parking brake console hood-to-tunnel bracket screws to 2.5 N.m (22 INCH lbs.). Snap in plastic caps that cover access holes to parking brake console hood-to-tunnel bracket screws. Adjust front seats to their previous position.
Filed Under (Jeep) by admin on 05-09-2010
Tags: adjustment nut,
alternator service,
electrical system,
engine compartment,
ft lbs torque,
generator drive,
jeep cherokee,
jeep truck,
left hand drive,
mounting bolt,
pivot bolt,
synthetic fiber
download
WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WERE (B+ WIRE) FROM GENERATOR. FAILURE TO DO S0 CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM. 1. Disconnect negative battery cable at battery. 2. Remove generator drive belt. 3. Left Hand Drive (LHD) Vehicles Only: Remove generator pivot and mounting bolts/nut. Position generator for access to wire connectors. 2000 Jeep Truck Cherokee 2WD L6-4.0L VIN S 4. Right Hand Drive (RHD) Vehicles Only:Remove upper nut (generator adjustment nut) and both belt adjustment bolts. Remove generator lower nut/bolt. Position generator for access to wire connectors. 5. If equipped, unsnap plastic cover from B+ terminal. 6. Remove B+ terminal mounting nut at rear of generator.Disconnect terminal from generator. 7. Disconnect field wire connector at rear of generator by pushing on connector tab. 8. Remove generator from vehicle. INSTALLATION 1. Position generator to engine and snap field wire connector into rear of generator. 2. Install B+ terminal to generator mounting stud. Tighten mounting nut to 8.5 Nm (75 in. lbs.) torque. 3. If equipped, snap plastic cover to B+ terminal. 4. LHD Vehicles: Install generator fasteners and tighten as follows: – Generator upper mounting bolt-55 Nm (41 ft. lbs.) torque. – Generator lower pivot bolt/nut-55 Nm (41 ft. lbs.) torque. CAUTION: – Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged. – When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment.
