2010 Subaru Legacy & Outback Steering Column Electrical Roll Connector replacement

0

Filed Under (Subaru) by admin on 04-01-2011

download
Steering Roll Connector Lot Number Verification 1) Start the engine and rotate the steering wheel 90 degrees from a straight-ahead position (either left or right rotation). Turn the ignition switch to the OFF position 2) Adjust the tilt position to the lowest position and lock the tilt lever. Remove the upper steering column cover screw on one side, rotate the steering wheel 90 degrees and remove the screw on the other side. 3) Release the claws and detach the steering column lower cover. 4) Confirm the steering roll connector lot number located on the left side of the connector. Affected Lot numbers Steering Roll Connectors requiring replacement were produced on or before October 13, 2009. Target Lot Numbers: 9X13A or before. How to read the Steering roll connector Lot number: Lot #: Five Characters Steering roll connector replacement 1) Position the front wheels straight ahead. (After moving vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead). 2) Record preset radio stations 3) Turn the ignition switch to OFF. 4) Disconnect the ground cable from the battery and wait at least 60 seconds before proceeding. 5) Remove the driver’s airbag module assembly. A TORX® T40 is required. Loosen the two TORX® bolts on the sides of the steering wheel.

GM AIRBAG STEERING WHEEL REPLACEMENT PROCEDURES

0

Filed Under (GM) by admin on 17-06-2010

download
This wheel will fit the following vehicles: (equipped with spoke mounted switches): Cadillac – 2003-06 Escalade, Escalade EXT and Escalade ESV Chevrolet/GMC – 2002-08 Trailblazer/Envoy 2003-06 Silverado/Sierra Pickups and Avalanche 2003-06 Suburban/Yukon XL 2003-06 Tahoe/Yukon and Denali 2003-06 Express/Savana Vans Hummer – 2003-06 H2 Oldsmobile – 2002-04 Bravada DISABLING AND REMOVAL OF THE AIRBAG MODULE 4. Lift and partially remove the airbag module from the steering wheel in order to expose the electrical connectors on the back side. Take care not to pull on any of the wiring. See Illustration 2 above. 5. The airbag electrical connections have a safety locking connector-position assurance (CPA) clip that must be disconnected before you can remove the electrical connectors from the module. 6. Disconnect the electrical connectors from the airbag module. 7. Remove the airbag module from the steering wheel and place the module face up on the floor, seat or work bench. If you carry the module make sure the trim cover is pointed AWAY from your body. REMOVING THE STEERING WHEEL FROM THE VEHICLE

Related entry:

gm headrest electrical clamps,