Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
Special Tools Required KTC trim tool set SOJATP2014* *Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Take care not to scratch the front seat, dashboard, and related parts. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. 1. M/T model: Remove the shift knob (A). -1 Lower the shift lever boot (B) to release the hooks (C) from the knob. 2. Detach the clips (A, B) by pulling the center console front panel (C) up. If equipped, disconnect the seat heater switch connectors (D). 3. Pry up on the right of the console pocket (A) with a trim tool, and detach the clips, then remove the pocket. 4. Remove the screws (A), detach the clips (B) and hook (C) by pulling the center holder (D) up, and disconnect the front accessory power socket connector (E). 5. Detach the clips (A, B) by pulling the center console rear panel (C) up. 6. Remove the center console (A). -1 Open the console box lid (B) then remove the console mat (C). -2 If equipped, disconnect the rear accessory power socket connector (D), and detach the clip (E). -3 Remove the screws (F, G), then pull the rear portion of the console up to release the hooks (H), then remove

download
Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program. NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components. Take care not to scratch the front seat, dashboard, and related parts. 1. Detach the clips (A, B), and release the hooks (C) by pulling the center console trim (D) from both sides. 2. Open the console box lid (A) then remove the console mat (B) and screws (C, D). 3. Slide the rear section of the center console (A) rearward to release the hooks (B). 4. Lift up the rear of the console (A). Release the harness retainer clip (B) from the air duct, and disconnect the console accessory power socket connector (C), the light bulb socket connector (D), and the AUX connector (E), then remove the rear section of the center console. 5. Install the console in the reverse order of removal, and note these items: Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones. Push the clips into place securely. Make sure the console accessory power socket connector and the AUX connector are plugged in properly, and the light bulb socket is connected securely.