Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
BUMPER COVER – REAR Exploded View Removal and Installation 1. Remove the 2 rear bumper cover lower screws (1 each side). To install, tighten to 5 Nm (44 lb-in) . 2. Remove the 4 rear bumper cover center screws. 3. Remove the 2 rear bumper cover lower pushpins. 4. Remove the 2 rear splash shield-to-rear bumper cover screws (1 each side). 5. Remove the 2 rear bumper cover upper screws (1 each side). To install, tighten to 5 Nm (44 lb-in) . 6. Remove the 2 liftgate alignment bumper bolts and the 2 liftgate alignment bumpers. To install, tighten to 8 Nm (71 lb-in) . 7. Disconnect the parking aid system or trailer tow electrical connector, if equipped. 8. Remove the rear bumper cover. 9. To install, reverse the removal procedure. When installing, position the rear bumper cover into the bumper slides.

download
REAR ABSORBER REMOVAL 1. Remove rear fascia, refer to (Refer to REAR FASCIA ). 2. Remove rivets attaching absorber to rear crossmember (Fig. 6 ). 3. Separate absorber from vehicle. INSTALLATION 1. Position absorber on vehicle. 2. Install rivets attaching absorber to rear crossmember. (Fig. 6 ) 3. Install rear fascia, refer to (Refer to 13 – FRAMES & BUMPERS/BUMPERS/FRONT FASCIA – INSTALLATION ). REAR FASCIA REMOVAL 1. Raise and support vehicle. 2. Remove wheels. 3. Remove plastic push pins attaching fascia to fuel tank skid plate. 4. Remove plastic rivets attaching fascia to wheel liner. 5. Remove nuts attaching upper edge of fascia to quarter panel and wheel liner (Fig. 5 ).