2006 Ford Explorer 6R60 Transmission Selector Lever Cable REMOVAL AND INSTALLATION

0

Filed Under (Ford) by admin on 07-05-2011

download
Selector Lever Cable Vehicles Equipped with a 6R60 Transmission Removal All vehicles 1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. 3. With the selector lever in PARK, disconnect the selector lever cable from the selector lever. Vehicle equipped with a 6R60 transmission 6. Remove the cable shield by prying on the shield closest to the boot, then sliding the shield away from the boot. 4. Disconnect the selector lever cable from the selector lever housing. 7. Unlock the lock tab and disconnect the selector lever cable end from the transmission manual lever. 5. Pull the cable and grommet through the floorpan. 8. Disconnect the selector lever cable from the bracket and remove the cable. Vehicles equipped with a 5R55S transmission 9. Remove the cable shield by prying on the side of the shield closest to the boot, then sliding the shield away from the boot. 10. Unlock the lock tab and disconnect the selector lever cable end from the transmission manual lever. 11. Disconnect the selector lever cable from the bracket and remove the cable. Installation Vehicles equipped with a 6R60 transmission 1. Install the selector lever cable into the bracket. 2. Connect the selector lever cable end onto the transmission manual lever and lock the lock tab. 3. NOTE: If the shield is loose, install a new shield. Install the cable shield. Vehicles equipped with a 5R55S transmission 4. Install the selector lever cable into the bracket. 5. Connect the selector lever cable end onto the transmission manual lever.

Related entry:

how to install 4wd selector on 2006 envoy denali, bmode in mirage, changing transmission selector cable in hummer, gear shift lever on 2005 Pacifica, how to replace the 4wd selector knob on an 2006 gmc envoy xl, hummer h2 shifter cable replacement removal, porsche 928 selector light, relay lever cable carrier how to replace in a 1999 vw beetle,

2002 Ford Truck Explorer Sport Trac Antenna Service and Repair

0

Filed Under (Ford) by admin on 27-06-2010

download
REMOVAL NOTE: The antenna base and the antenna upper cable are removed as an assembly. Zoom Sized for Print 1. Remove the radio antenna mast. Remove the radio antenna mast by turning it counterclockwise. 2. Unsnap the radio antenna base cap. 3. Remove the screws. 4. Remove the front fender apron. 1 Remove the screws. 2 Remove the bolts. 5. Remove the lower antenna mounting screw. 6. Remove the antenna cable. 1 Open the glove box door. 2 Release the tabs and lower the glove box to the full open position 3 Release the antenna lead-in cable clips. 4 Disconnect the connector. 5 Push the antenna lead-in cable into the engine compartment. 7. Remove the antenna base and the antenna lead-in cable. INSTALLATION 1. To install, reverse removal procedure

Related entry:

antenna wiring diagram for 1998 chevy 1500 truck, how to replace an antenna on a 2001 ford explorer, video of how to change an antenna on a ford explorer,