download
The Fuel Pump Relay is located on the Fuse Block – Underhood Bracket. The Fuse Block – Underhood is located on the left side of the engine compartment to the rear of the battery. NOTE: This is the secondary fuel pump relay used for vehicles with dual tanks only. This vehicle does not use a primary fuel pump relay.
download
Removal Procedure 1. Remove the upper fan shroud. 2. Install the J 46406 to the fan clutch. 3. Remove the fan hub nut from the water pump in a counterclockwise rotation. 4. Remove the fan clutch bolts from the rear of the fan blade. 5. Separate the fan clutch from the fan blade. Installation Procedure 1. Install the fan clutch bolts from the rear of the fan blade. 2. Notice: Refer to Fastener Notice in Service Precautions. Install the fan clutch bolts. Tighten the bolts to 23 Nm (17 ft. lbs.). 3. Install the fan assembly. 4. Install the J 46406 to the fan clutch. Tighten the nut clockwise to 56 Nm (41 ft. lbs.). 5. Install the upper fan shroud.
download
Remove the HVAC module. 2. 3. 4. 5. Disconnect the electrical connector (3) from the mode actuator (4). Remove the screws from the mode actuator (4). Remove the mode actuator (4) from the HVAC module (1). Remove the wiring harness from the air distribution housing (1). 6. Remove the screws from the air distribution housing (1). 7. Remove the air distribution housing (1) from the HVAC module (2). 8. Remove the screws from the upper recirculation housing (1). 9. Remove the upper recirculation housing (1) from the HVAC module (2). 10. Remove the screws from the lower recirculation housing (1). 11. Remove the lower recirculation housing (1) from the HVAC module (2). 12. Remove the wiring harness from the HVAC module. 13. Remove the screws from the HVAC module. 14. Remove the upper HVAC module case (1) from the lower HVAC module case (2). 15. Remove the right temperature door (2) from the upper HVAC module case (1). INSTALLATION PROCEDURE
download
1. If equipped, remove the IP sound insulator. 2. Disconnect the electrical connection from the blower motor. 3. Disconnect the electrical connection from the blower motor resistor. Remove the blower motor resistor retaining screws. 5. Remove the blower motor resistor. INSTALLATION PROCEDURE 1. Install the blower motor resistor. NOTE: Refer to Fastener Notice in Service Precautions. 2. Install the blower motor resistor retaining screws. Tighten Tighten the screws to 1.6 N.m (14 lb in) . 3. Connect the electrical connection to the blower motor resistor. 4. Connect the electrical connection to the blower motor. 5. If equipped, install the IP sound insulator.
