Filed Under (Toyota) by admin on 24-09-2010
download
Vehicles S 2002 – 2004 model year 4Runner, Corolla, and MR2 Spyder vehicles. S 2003 – 2004 model year Highlander, Matrix, Sienna, and Solara vehicles. Parts Information PREVIOUS PART NUMBER 90987–02022 CURRENT PART NUMBER 90987–02028 PART NAME Relay, Magnet–Clutch Inspection Procedure 1. Locate the A/C magnetic clutch relay. 2. Verify the part number printed on the side of the relay. A. If the part number is 90987–02022, please replace the relay with the countermeasured relay P/N 90987–02028. B. If the part number does not match 90987–02022, then please diagnose problems by referring to the Technical Information System (TIS): applicable model year and vehicle Repair Manual: Air Conditioning: Troubleshooting.
Filed Under (Toyota) by admin on 14-06-2010
Tags: 1991 toyota mr2,
4runner,
celica,
corolla,
cressida,
engine performance,
land cruiser,
schematics,
tercel,
vacuum diagrams,
vacuum hoses
download
ARTICLE BEGINNING 1991 ENGINE PERFORMANCE Vacuum Diagrams Camry, Celica, Corolla, Cressida, Land Cruiser, MR2, Pickup, Previa, Supra, Tercel, 4Runner INTRODUCTION This article contains underhood views or schematics of vacuum hose routing. Use these vacuum diagrams during the visual inspection in F – BASIC TESTING. This will assist in identifying improperly routed vacuum hoses which cause driveability and/or computer-indicated malfunctions. CAMRY VACUUM DIAGRAMS
Filed Under (Toyota) by admin on 14-06-2010
Tags: 4runner,
camry,
case transfer,
celica,
corolla,
differential,
drain plugs,
service intervals,
supra,
tercel,
transaxle,
transfer case,
transmission case,
wagons
download
LUBRICATION SERVICE INTERVALS Check lubricant level every 20,000 on all except 4WD Pickups. On 4WD Pickups, check every 15,000 miles. Replace fluid if vehicle is operated in severe service conditions. CHECKING FLUID LEVEL Transmission Check lubricant level at fill plug hole. Lubricant should be to bottom of hole. Transmission on Tercel Wagon has 2 drain plugs on bottom of transaxle. Transfer Case (Except Tercel Wagon) Drain plugs on 4WD transfer cases are separate from main transmission case. Transfer Case (Tercel Wagon) The integral differential and transaxle assembly on Tercel Wagons have separate drain and fill plugs. See Fig. 1. When filling with fluid, leave extension housing drain plug loose about 7 or 8 turns. After filling, tighten drain plug.
Filed Under (Toyota) by admin on 21-05-2010
Tags: air conditioner unit,
ambient temperatures,
assembly procedure,
corolla,
drain coolant,
hfc 134a,
performance improvement,
r 134a refrigerant,
recycling,
refrigerant recovery,
unit assembly
download
Introduction Customers in areas with extremely low ambient temperatures may complain of poor heater performance during city driving conditions. The Air Conditioner Unit Assembly has been modified to improve this condition. S 2003 – 2005 model year Corolla vehicles produced BEFORE the Production Change Applicable Replacement
Install Air Conditioner Unit Assembly. Procedure Air Conditioner Unit Assembly 1. Evacuate Refrigerant HFC–134a (R–134a).
S Equipment: Robinair R–134a Refrigerant Recovery/Recycling Machine (Robinair P/N: 342000) 2. Disconnect Negative Terminal of Battery. 3. Drain Coolant.
Filed Under (Toyota) by admin on 21-05-2010
download
Introduction Under certain conditions customers may experience a MIL “ON” condition with DTC P1349 indicating a variable valve timing (VVTi) malfunction. In some cases, the cause of this DTC may be the VVTi actuator. Use the procedures in this bulletin to verify the
operation of the actuator. S 2000 – 2002 model year Corolla, Celica, MR2 Spyder, and ECHO vehicles
Applicable Vehicles produced BEFORE the Production Change Effective VINs shown below.
