Filed Under (Chevrolet) by admin on 01-07-2010
download
REMOVAL PROCEDURE The power antenna is serviced as a complete unit only, however an antenna (mast) which has been bent or broken can be replaced, rather than replacing the complete power antenna. 1. Using the socket (1) provided with the antenna (mast) service kit, remove the antenna mast nut (2). 2. Turn the ignition to the ACC or ON position. 3. Turn the radio ON to raise the power antenna. IMPORTANT: Prior to complete removal, note the orientation of the serrated side of the antenna mast plastic cable (5). The antenna mast plastic cable (5) will likely coil back once removed, take precautions to avoid grease splatter on the vehicle. 4. Remove the antenna mast (4) with the contact spring (3). It may be necessary to gently pull the mast up by hand to release and remove. 5. Turn the radio OFF. 6. Turn the ignition OFF. INSTALLATION PROCEDURE
Filed Under (Chevrolet) by admin on 04-05-2010
Tags: bearings,
Chevrolet,
Chevrolet Corvette,
column position,
corvette v8,
hex head,
pivot pins,
release lever,
shaft assembly,
spring assembly,
spring coat,
spring guide,
steering column,
steering wheel lock,
tilt
download
Fig. 59 Steering Column Exploded View (Part 1 Of 2). Fig. 59 Steering Column Exploded View (Part 2 Of 2). STEERING COLUMN HOUSING, SWITCH ACTUATOR RACK, STEERING WHEEL LOCK SHOES, BEARING ASSEMBLY & STEERING SHAFT ASSEMBLY Assembly 1. Install bearings (Nos. 22 and 33) to column housing, then install driveshaft, switch actuator sector and lock shoes (Nos. 25 and 26). 2. Install dowel pin, lock shoe springs, release lever spring, shoe release lever, release lever pin and rack preload spring (Nos. 28, 30, 31, 34, 32 and 36). 3. Install switch actuator rack to switch actuator sector, then install lock bolt, lock bolt spring and hex head screw. 4. Install column housing assembly to column. Position column housing support, then position column housing assembly and align switch actuator rack with pin on end of switch actuator assembly. 5. Pull back on tilt lever and push column housing onto column housing support. Release tilt lever to lock shoes. 6. Remove tilt lever, then install pivot pins, spring guide and spring. Coat all parts with lithium grease. 7. Follow installation procedure from LOCK HOUSING COVER, COVER END CAP, DIMMER SWITCH ROD ACTUATOR & TILT
SPRING ASSEMBLY to complete installation.
