2005 Jaguar S-Type IMT O-Ring replacement (short route)

0

Filed Under (Jaguar) by admin on 20-11-2010

download
Disconnect wiper washer supply lines, being very carefull not to snap off nipples! Remove wiper arm 13mm (socket) nut covers, loosen nuts to top of stud. Grab ahold of wiper arm closest with small hammer (arm assembly should “pop” on third hit). DO NOT remove nut then strike stud this wil everything else is down hill. If not have someone else do the replacement. Using “optional” nail set, push down on center push/pull pin on front cowl (8 pieces). Using flat screw drive (To reinstall these, push the pin from the underside up so it protrudes the top of its washer). Remove (7) rear cowl T20 screw covers and screws. You are now able to slide cowl cover away from work underneath cowl, it has alot of play to just set over front of engine bay. Optional use vacuum to suck up what appears to be paper fiber insulation under cowl and rear of engine b time to clean wiper arm drain as well (drivers side US) Remove (4) crossbar 13mm (socket) bolts, set bar aside Now theres a clear but very tight view of the IMT tuner valves. Disconnect wire harness using thumb pres wrench) remove (2) tuning valve bolts, wiggle valve out of intake manifold. Tricky part now is to find the r engine bay. Lower IMT tuning valve same removal process. There may be as much as a 1/3 cup of oil that cleaner, clean the lower IMT port. Replace yellow IMT O-Ring with new GREEN O-Ring.

2008 HONDA ODYSSEY SKI ATTACHMENT INSTALLATION

0

Filed Under (Honda) by admin on 17-08-2010

download
1. If equipped, remove the roof rack crossbars and end caps. Remove the four TORX bolts, four lock washers, and four washers from the front and rear crossbars, then remove the crossbars. Remove the four TORX self-tapping screws and eight washers from the crossbars, then remove the caps. Odyssey (EX): INSTALLATION NOTE: • The ski attachments are designed to be used exclusively with a Honda roof rack, which is sold separately. If the vehicle is not equipped with a roof rack, have the recommended roof rack on hand and install the roof rack before installing the ski attachment. • The ski attachments may be installed either with both on the driver’s side or with both on the passenger’s side. . INSTALLATION NOTE: • The ski attachments are designed to be used exclusively with a Honda roof rack, which is sold separately. If the vehicle is not equipped with a roof rack, have the recommended roof rack on hand and install the roof rack before installing the ski attachment. • The ski attachments may be installed either with both on the driver’s side or with both on the passenger’s side. . 4. Slide the two long bolts into each crossbar. Odyssey (EX): 6. Insert the key, and turn it clockwise to unlock the front ski attachment. Press the button, and open the top frame completely.