Filed Under (Dodge) by admin on 27-12-2010
download
1. The PCM is located between driver’s side front fender and power distribution center, near battery. See Fig. 1 . Disconnect negative battery cable and then positive battery cable from battery. 2. Remove bolts on side of power distribution center that secure power distribution center to mounting bracket. Remove heat shield from outside of battery. Remove battery. 3. Rotate power distribution center toward the engine to disengage power distribution center from rear mounting bracket. Pull power distribution center toward rear of vehicle to disengage power distribution center from front mounting bracket. 4. Allow power distribution center to lay aside for access to PCM. Remove electrical connectors from PCM. Electrical connectors may be removed by squeezing tabs on electrical connector together and pulling electrical connector from PCM. Remove bolts and PCM. To install, reverse removal procedure.
Filed Under (Chrysler) by admin on 09-12-2010
download
SYMPTOM/CONDITION: DIAGNOSIS: 1. Verify the rear of the sunroof glass to roof flushness concern. 2. UNCALIBRATE THE SUNROOF. a. b. c. d. e. 3. RECALIBRATE THE SUNROOF a. b. c. 4. If the uncalibrate/recalibrate procedure did not eliminate the sunroof glass to roof fit, use the procedures outlined in TechCONNECT(R) BODY/SUNROOF/GLASS PANEL/ADJUSTMENTS to adjust the glass panel. If the sunroof glass is now flush, perform the Repair Procedure. If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure. Insure the battery is at least 12 Volts. Place the ignition switch in RUN position. Locate the sunroof fuse (Fuse 44 in the Power Distribution Center located in the trunk). While the sunroof is still in motion, have an assistant remove the sunroof fuse. Reinstall the sunroof fuse. Press and hold the sunroof vent switch until it stops at the full vent position. Verify sunroof operation by opening, closing, and venting the sunroof. If the uncalibrate/recalibrate procedure corrected the sunroof glass to roof fit, perform the Repair Procedure.
Filed Under (Jeep) by admin on 23-08-2010
download
The Power Distribution Center (PDC) cover, the PDC housing lower cover, the PDC relay wedges, the PDC relay cassettes and the PDC B(+) terminal stud module (WJ only) are available for service replacement (Fig. 1 and Fig. 2). The PDC cover can be simply unlatched and removed from the PDC housing without the PDC being removed or disassembled. Service of the remaining PDC components requires that the PDC be removed from its mounting and disassembled. Refer to Wiring Repair in the index of this service manual for the location of the wiring repair procedures.
