Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
REMOVAL 1. Open Hood. 2. Disconnect the negative battery cable. 3. Raise vehicle and support. 4. Remove the accessory drive belt splash shield. 5. Loosen the accessory drive belt refer to the cooling. 6. Remove the lower mounting bolt. 7. Lower the vehicle. Fig.5 Generator Battery Cable 8. Remove the battery cable and field connection (Fig. 5). 9. Disconnect the electrical connector to the A/C pressure switch and A/C clutch. 10. Remove the engine oil dip stick. 11. Remove the 2 upper mounting bolts. 12. Remove the generator (Fig. 6). INSTALLATION 1. Install generator (Fig. 6). 2. Install the 2 upper bolts but do not tighten. 3. Install the engine dip stick tube. 4. Connect the A/C pressure switch and A/C clutch electrical connectors. 5. Connect the battery cable and field connectors (Fig. 5). 6. Raise vehicle and support. 7. Install the lower bolt and tighten. 8. Install the accessory drive belt, refer to the cooling. 9. Install the accessory drive splash shield. 10. Lower the vehicle. 11. Tighten the 2 upper mounting bolts to 12. Connect the negative battery cable.

download
Fascia Replacement – Front Bumper Removal Procedure 1. Raise and support the vehicle. Refer to Vehicle Lifting(). 2. Remove the front fascia extensions. 3. Remove the front push-in fasteners that secure the lower air deflector to the fascia. 4. Disconnect the fog lamp/ turn signal electrical connectors (1). 5. Remove the bolts (2) that secure the bumper fascia to the front fender. 6. Remove the push-in retainers (1) across the top side of the fascia. 7. Loosen approximately 4 turns, the inner fastener nut (2) securing the fascia to the inner fender. 8. Loosen the fascia from the key slots at the inner fender attachments. 9. With an assistant, remove the fascia by pulling the fascia forward from the vehicle. Installation Procedure 1. With an assistant, position the fascia (3) to the vehicle. Install 2 push-in retainers (1) in order to hold the fascia to the upper tie bar. 2. Position the fascia to the key slot at the inner fender.

download
1. Disconnect the negative battery cable. 2. Remove the center molding. Refer to Center Molding Removal and Installation. 3. Remove the screws and the audio system. 4. Disconnect the audio system electrical connectors.
Installation 1. Connect the audio system electrical connectors. 2. Install the audio system with the screws. Tighten: Tighten the audio system screws to 4 Nm (35 in. lbs.) . 3. Install the center molding. Refer to Center Molding Removal and Installation.

download
Intake Manifold: Service and Repair Upper Upper Intake Manifold Removal 1. Disconnect the battery ground cable. 2. Remove the air cleaner assembly and the air cleaner outlet tube. 3. Remove the pin-type retainers and the snow shield.
4. Disconnect the accelerator cable, speed control actuator cable and the throttle return spring from the throttle body. 5. Remove the bolts, then position the accelerator cable bracket aside. 6. Disconnect the hoses.- Disconnect the vacuum hose. – Disconnect the evaporative emissions return tube. 7. Disconnect the electrical connectors. – Disconnect the Idle Air Control (IAC).
- Disconnect the Throttle Position (TP) sensor. 8. Disconnect the engine wiring harness from the intake manifold support bracket.