Filed Under (Ford) by admin on 07-11-2010
download
Special Tool(s) Removal and Installation 1. Remove the radiator. 2. Disconnect the cooling fan clutch electrical connector. Unclip and position the fan wiring aside. 3. NOTE: Use a hole in the fan hub to prevent the fan from turning. Using the special tool, remove the cooling fan and clutch. To install, tighten to 133 Nm (98 ft. lbs.) . 4. If necessary, remove the bolts and separate the cooling fan and the clutch. To install, tighten to 17 Nm (13 ft. lbs.) . 5. To install, reverse the removal procedure.
Filed Under (Chevrolet) by admin on 20-08-2010
download
Removal Procedure 1. Remove the upper fan shroud. 2. Install the J 46406 to the fan clutch. 3. Remove the fan hub nut from the water pump in a counterclockwise rotation. 4. Remove the fan clutch bolts from the rear of the fan blade. 5. Separate the fan clutch from the fan blade. Installation Procedure 1. Install the fan clutch bolts from the rear of the fan blade. 2. Notice: Refer to Fastener Notice in Service Precautions. Install the fan clutch bolts. Tighten the bolts to 23 Nm (17 ft. lbs.). 3. Install the fan assembly. 4. Install the J 46406 to the fan clutch. Tighten the nut clockwise to 56 Nm (41 ft. lbs.). 5. Install the upper fan shroud.
Filed Under (Ford) by admin on 04-05-2010
download
See Figure 1 Fig. 1: Exploded view of the engine fan for the 2.3L and 2.5L engine The 2.3L and 2.5L engine does not use a fan hub nut. It is retained by four bolts which also secure the pump pulley to the water pump. 1. If not equipped with A/C, disconnect the overflow tube from the fan guard, then unbolt and remove the guard. 2. If equipped with A/C, disconnect the overflow tube from the shroud, remove the mounting screws and lift the shroud off the brackets. Place the shroud behind the fan. 3. Remove the 4 clutch/fan assembly-to-pulley screws and remove the
