Filed Under (Ford) by admin on 08-01-2011
download
ISSUE Some 2003 F250-550 Super Duty and Excursion vehicles equipped with a 6.0L Powerstroke engine, may exhibit a difficult to remove or replace air filter assembly during service. ACTION The following procedure has been provided to assist with air filter removal or installation during service. SERVICE PROCEDURE Filter Removal 1. Release 4 toggle clamps located on top of assembly (Figure 1). 2. Lift inlet slightly, enough to disengage the 2 tabs on the bottom of the inlet cover from the 2 windows on bottom of the filter inlet, and push it forward toward front of vehicle as shown in Figures 2 and 3. 4. Pull outlet cover up enough to disengage the 2 tabs on the outlet cover and the filters 2 windows located at the bottom of the clean side. At this step, the MAFS may contact the degas bottle while pulling the cover up but this should not create a problem. Push cover slightly away from filter and down as in Figure 5. 5. Pull filter upward to disengage its 2 legs from grommets (Figure 6). It is easiest to rock the filter forward/aft while pulling it up. Filter Installation 1. Use the guide on the filter to align its legs to the grommet during its installation as shown in Figure 7, making sure filter is fully seated on the cradle. 2. Attach inlet cover to filter using the 2 clamps on inlet side, making sure that tabs are seated inside the windows (Figure 8).
Filed Under (Chevrolet) by admin on 19-08-2010
download
IMPORTANT: Inspect the fuel tank internally and clean the fuel tank if you find a restricted fuel filter. 1. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief Procedure. 2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle. 3. Clean all the fuel filter connections and the surrounding areas before disconnecting the fuel pipes in order to avoid possible contamination of the fuel system. 4. Disconnect the threaded fittings (1, 2) from the fuel filter. 5. Remove the fuel filter bracket bolt (4). 6. Cap the fuel pipes in order to prevent possible fuel system contamination. 7. Slide the fuel filter from the bracket. 8. Inspect the fuel pipe O-rings for cuts, nicks, swelling, or distortion. Replace the O-rings if necessary. INSTALLATION PROCEDURE 1. Slide the fuel filter into the bracket. 2. Remove the caps from the fuel pipes. NOTE: Refer to Fastener Notice in Service Precautions. 3. Connect the threaded fittings (1, 2) to the fuel filter. Tighten ^ Tighten the fittings to 25 N.m (18 lb ft)Tighten the fuel filter bracket bolt (4), to 12 N.m (106 lb in). 4. Lower the vehicle. 5. Tighten the fuel filler cap. 6. Connect the negative battery cable. 7. Use the following procedure in order to Inspect for leaks. 7.1. Turn ON the ignition, with the engine OFF, for 2 seconds. 7.2. Turn OFF the ignition for 10 seconds. 7.3. Turn ON the ignition, with the engine OFF. 7.4. Inspect for fuel leaks. 7.5. Install the engine sight shield
Filed Under (Subaru) by admin on 24-07-2010
download
1. Remove the instrument panel side cover. 2. Remove the clip and the damper (string). 3. Remove the upper storage box. 4. Remove the screws, and then remove the cover. 5. Remove the A/C filter. 6. Install in the reverse order of removal. Vehicle Level Maintenance Filters Cabin Air Filter Service and Repair 2009 Subaru Outback F4-2.5L
