Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
SYMPTOM One or both of the front windows are binding or have come out of the window run channel. PROBABLE CAUSE 1996 and 1997 models thru the affected VINs: Faulty window regulator, and the glass run channel is not seated correctly in the window channels. 1997 models after the affected VINs, all 1998–99 models, and 2000 models thru the affected VINs: The glass run channel is not seated correctly in the window channels. VEHICLES AFFECTED Replace the window regulator(s), and reinstall the glass run channel on these vehicles: REPAIR PROCEDURE 1. Remove the door panel. Refer to section 20 of the 1996-00 Civic Service Manual. 2. Remove the armrest bracket, then pull down the plastic cover to gain access to the window regulator. 3. Carefully move the glass until you can see the glass mounting bolts, then loosen them. Slide the guide rearward, remove the glass from the guide, and carefully pull the glass out through the window slot. 4. Check the year and VIN. • If the vehicle is a 1996 or 1997 within the affected VIN range, replace the window regulator. Go to step 5. • If the vehicle is not a 1996 or 1997 within the affected VIN range, go to step 8. 5. Remove the two roller guide bolts and the two rear regulator mounting bolts; then remove the front regulator mounting bolts.

download
1. Remove: Door panel Plastic cover Inner molding Inner sash trim Sash trim 2. Carefully move the glass until you can see the bolts, then remove them. Carefully pull the glass out through the window slot. NOTE: Take care not to drop the glass inside the door. 3. Remove the glass run channel as needed, remove the bolts and screw, then move the rear channel forward. 4. Remove the quarter glass. NOTE: When installing the quarter glass, make sure the outer molding lip is not pinched. 5. Disconnect the connector, then remove the regulator through the hole in the door. 6. Grease all the sliding surfaces of the regulator where shown. 7. Installation is the reverse of the removal procedure. NOTE: Roll the glass up and down to see if it moves freely without binding. Also make sure that there is no clearance between the glass and glass run channel when the glass is closed. Adjust the position of the glass as necessary.

download
Setting of limit switch If any of the following work has been done, set the limit switch (integrated in the motor). Removal and installation of the motor from the regulator. Operate the regulators as a unit. Installation of the new glass. Installation of the new glass run. Resetting After installing each component to the vehicle, follow the steps below. 1. Raise the grass to the top dead center. 2. While pressing and holding the reset switch, lower the glass to the bottom dead center. 3. Release the reset switch, and check the reset switch returns to the original position, and then raise the glass to the top dead center. CAUTION: Do not
operate the glass automatically to raise the glass to the top dead center.