Filed Under (Suzuki) by admin on 19-06-2010
Tags: crankshaft,
crankshaft pulley,
distributor cap,
dohc,
hydraulic lifters,
mpi,
rotor,
sidekick,
suzuki samurai,
suzuki swift,
tdc,
timing belt,
valve clearance
download
Suzuki; Samurai, Sidekick, Swift ENGINE MECHANICAL Before performing any on-vehicle adjustments to fuel or ignition system, ensure engine mechanical condition is okay. VALVE CLEARANCE NOTE: Swift DOHC uses hydraulic lifters. No adjustments are required. Samurai & Sidekick 1) Remove valve cover. Rotate engine until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley. See Fig. 1. 2) Ensure cylinder No. 1 is at TDC on compression stroke. Remove distributor cap. On Samurai and Sidekick (TBI), ensure rotor is pointed upward at distributor hold-down bolt and to No. 1 terminal of distributor cap. On Sidekick (MPI), ensure rotor is at about 1 o’clock position and pointed to No. 1 terminal of distributor cap. If rotor is not as described, rotate crankshaft 360 degrees
Filed Under (volkswagen) by admin on 18-06-2010
Tags: belt tensioner,
clutch slave cylinder,
front bumper,
fuel pump relay,
hydraulic lifters,
manual transmission models,
overhaul procedures,
power steering pump,
repair overhaul,
valve clearance,
volkswagen corrado
download
ADJUSTMENTS VALVE CLEARANCE Engine is equipped with hydraulic lifters. Adjustment is not necessary. REMOVAL & INSTALLATION FUEL PRESSURE RELEASE Remove fuel pump relay (lower right relay located in fuse/relay panel). start engine and let idle until it stalls. Crank engine for an additional 5 seconds. Reinstall fuel pump relay. ENGINE NOTE: Engine is removed with transaxle attached. Removal 1. Obtain radio code. Turn ignition off and wait 20 seconds. Disconnect negative battery cable. Remove air cleaner assembly. Install 8-mm bolt in belt tensioner hole and remove service belt. See Fig. 2 . 2. On manual transmission models, disconnect clutch slave cylinder. On all models, remove power steering pump and attach to body. DO NOT disconnect power steering hoses. Remove radiator, front lock support and front bumper. Drain cooling system. Disconnect cooling fan and thermoswitch.
Filed Under (Volvo) by admin on 15-06-2010
download
ADJUSTMENTS VALVE CLEARANCE ADJUSTMENT Engine is equipped with hydraulic lifters. No valve adjustment is necessary. REMOVAL & INSTALLATION NOTE: For reassembly reference, label all electrical connectors, vacuum hoses and fuel lines before removal. Also place mating marks on other major assemblies before removal. Hood removal is not necessary, as hood opens to horizontal position. Removal and installation information for turbocharger is not available from manufacturer. FUEL PRESSURE RELEASE Fuel Pump Pressure Release Before disconnecting any lines, cover fuel line connector with shop towel to absorb any fuel left in line. With ignition key removed from ignition switch, reconnect relay. ENGINE
