Filed Under (KIA) by admin on 16-08-2010
Tags: cruise control,
exhaust manifold,
fuel injector,
fuel rail,
inner fender,
intake manifold,
kia spectra,
knock sensor,
maf sensor,
position sensor,
power steering pump,
radiator hoses,
throttle body
download
Initial disassembly 1. Disconnect the battery. Remove battery and the battery tray. 2. Using floor jack, elevate front end and place securely on jack stands. 3. Drain the coolant from the radiator. Capture and save for re-use. 4. Remove both upper and lower radiator hoses. 5. Remove front bumper. 6. Remove both headlights. 7. Remove steel inner bumper. 8. Remove the entire air cleaner assembly, including housing, ducting, and the MAF sensor. 9. Disconnect and remove horns. 10. Remove dipstick and dipstick tube. 11. Remove exhaust manifold. Remove oxygen sensor from manifold for reuse. 12. Loosen alternator tensioner and remove alternator belt. 13. Remove power steering pump belt and then pump (Note: Do not remove lines from pump, lay pump over towards inner fender). 14. Remove power steering pump bracket. 15. Remove bracket holding wires to Crank Position Sensor and Oil Temp Sensor. Cylinder head removal/installation NOTE: THIS PROCEDURE DOES NOT INCLUDE DETAILED INSTRUCTIONS FOR THE REMOVAL/REPLACEMENT OF MAJOR COMPONENTS. PLEASE REFER TO THE MANUFACTURERS SERVICE MANUAL. 1. Remove all electrical connections from the intake manifold. This includes disconnecting all sensor plugs from the throttle body and manifold, removing the fuel injector wiring harness, removing the ground strap, and disconnecting the knock sensor. 2. Disconnect the throttle and cruise control cables from the throttle body and lay cables to sides of engine bay. 3. Disconnect the fuel rail supply hose. Remove fuel rail, complete with injectors. 4. Disconnect the hose from the EVAP canister to the manifold, and unclip canister from manifold.
Filed Under (KIA) by admin on 06-07-2010
download
Vehicle Level Powertrain Management Ignition System Ignition Coil Service and Repair Service and Repair REPLACEMENT IGNITION COIL 1. Remove the engine cover. 2. Disconnect the spark plug cables and the ignition coil connector. 3. Remove the ignition coil (A). 4. Installation is the reverse of removal. 2006 Kia Spectra L4-2.0L – Service and Repair
Filed Under (KIA) by admin on 13-06-2010
download
Air Quality Sensor At center front of engine compartment. Camshaft Position Sensor On rear of cylinder head. See Fig. 1 . Chassis Acceleration Sensor At right rear side of engine compartment. Crankshaft Position Sensor On left front side of transaxle. See Fig. 1 . Engine Coolant Temperature On top rear of engine, near thermostat. See Fig. 1 . Sensor Fuel Tank Unit On top of fuel tank, below rear seat cushion. Hot Film Airflow Sensor On end of air intake hose, at air cleaner housing. See Fig. 1 . Knock Sensor Near center rear of engine compartment, on intake manifold support bracket. O2 Sensor (Down) On front exhaust pipe, downstream of warm-up TWC converter. O2 Sensor (Up) On exhaust manifold, upstream of warm-up TWC converter. Speed Sensor On top of transaxle. Thermocon Behind glove box, on HVAC assembly. See Fig. 2 . Throttle Position Sensor On throttle body. See Fig. 1 . Turbine Sensor (A/T) On top rear of transaxle. Wheel Speed Sensor (Left Front) Attached to left front hub spindle. Wheel Speed Sensor (Left Rear) Attached to left rear hub spindle. Wheel Speed Sensor (Right Attached to right front hub spindle. Front) Wheel Speed Sensor (Right Rear) Attached to right rear hub spindle.
