Filed Under (Toyota) by admin on 22-07-2010
download
REMOVAL 1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Upper Instrument Panel\Removal 2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Upper Instrument Panel\Removal 3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Upper Instrument Panel\Removal 4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Upper Instrument Panel\Removal 5. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Upper Instrument Panel\Removal 6. REMOVE RADIO RECEIVER WITH BRACKET (b) Pull the radio receiver with bracket toward the rear of the vehicle and disengage the 4 clips. (c) Disconnect each connector and remove the radio receiver with bracket. 7. REMOVE NO. 2 RADIO BRACKET
Filed Under (Hyundai) by admin on 09-07-2010
download
PACKAGE TRAY 1. Remove the trim. NOTE: Put on gloves to protect your hands. When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. Take care not to bend or scratch the trim and panels. 2. Installation is the reverse of removal. NOTE: Replace any damage clips. Vehicle Level Body and Frame Interior Moulding / Trim Rear Shelf Service and Repair Service and Repair
Filed Under (Mercedes-Benz) by admin on 14-05-2010
download
Removal & Installation of Hydraulic Cylinder For Soft Top Bow Preliminary work: Coupe roof removed (See Owner’s Manual)
Parcel shelf removed. See: Interior Moulding / Trim\Service and Repair Occasional seats removed. See: Seats\Service and Repair
Rear side wall removed Soft top open Screws screw out (fig. 1, item 1) Gasket on loosen and remove cover (fig. 1, item 2)
B-pillar Screw screw out through opening in B-pillar with 5 mm Allen wrench (fig. 2, item 3) NOTE: Install screw with screw securing agent, part no. 002 989 94 71. Plug connection disconnect (fig. 3, S84/6x, only when removing left hydraulic cylinder)
Soft top position adjust by hand (fig. 4)
