Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
This How-to is based of the 2006 Toyota Corolla LE Step 1. Disconnect battery lead because of air bag sensors [Note: you WILL lose all of your radio presets…so you might want to write them down before moving forward.] Step 2. Pop off trim around shifter stick (I just lifted it up form the bottom with my finger nails) Step 3. Disconnect the Aux power, (not necessary, but it gets stuff out of the way) it just pulls right off Step 4. Remove center knob on the A/C panel (Just pull it straight out). Remove Phillips screw behind the knob this is the only screw that has to come out (in addition to the 4 radio screws) Step 5. Pull the a/c console forward. It’s a tight fit but it’s only held by clips. This was the most difficult part for me because I didn’t want to break anything. It eventually released after pulling with constant pressure. I found that pulling from the inside of the knob helped allot. Once the top part was off, pulling from the right edge of the console released the rest of it. Step 6. Disconnect these 4 Cables. Once you have done so the whole center console comes right out (make sure that the car is in neutral or else the shifter will be in the way and you won’t be able to take out the center console.) (I don’t think this step is necessary but again, it gives you more room to work and the doesn’t take any time at all to do so) (What it looks like then the shifter plate and the center console are removed)

download
1. Disconnect the negative battery cable. 2. Remove the hole covers by inserting a small, tape-wrapped, flathead screwdriver into the slot and carefully prying them off without scratching the center lower panel. Pry up and pull off the hole covers carefully to prevent the posts from breaking off. 3. With the beveled parts of the SST facing inward, insert them into the audio unit. 4. Pull the SST as shown to slide out the audio unit. 5. Disconnect the audio unit connector and antenna jack to remove the audio unit. INSTALLATION CAUTION: Make certain that the wiring harness and antenna feeder are not caught between the audio unit and center lower panel. If the harness or antenna feeder is caught between the audio unit and center lower panel, it may become the cause of trouble or malfunctions. 1. 2. 3. 4. Connect the audio unit connector and antenna jack. Insert the audio unit until each clip clicks. Insert the hole covers. Connect the negative battery cable.

download
SRS wire harnesses are routed near the steering column and passenger’s side dashboard. CAUTION: All SRS wiring harnesses are covered with yellow outer insulation. Before disconnecting any part of the SRS wire harness, install the short connectors. Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring. STEREO RADIO/CASSETTE REPLACEMENT NOTE (L and LS models): These versions have a stereo radio/cassette player with a 5-digit coded theft protection circuit. Be sure to get the code number before: -disconnecting the battery. removing the No. 56 (7.5 A) fuse. removing the radio. After reconnecting power and turning the radio ON, the word “CODE” will be displayed. Then enter the code. 1. Remove the center console panel.

download
1. Remove the center facia panel. 2. Loosen the screws 3. Disconnect the audio connector (A) and antenna cable (B), then remove the audio assembly (C) Vehicle Level Accessories and Optional Equipment Radio, Stereo, and Compact Disc Service and Repair Removal and Replacement Removal and Replacemen